| OMAP GLUE |
| |
| OMAP MUSB GLUE |
| - compatible : Should be "ti,omap4-musb" or "ti,omap3-musb" |
| - ti,hwmods : must be "usb_otg_hs" |
| - multipoint : Should be "1" indicating the musb controller supports |
| multipoint. This is a MUSB configuration-specific setting. |
| - num_eps : Specifies the number of endpoints. This is also a |
| MUSB configuration-specific setting. Should be set to "16" |
| - ram_bits : Specifies the ram address size. Should be set to "12" |
| - interface_type : This is a board specific setting to describe the type of |
| interface between the controller and the phy. It should be "0" or "1" |
| specifying ULPI and UTMI respectively. |
| - mode : Should be "3" to represent OTG. "1" signifies HOST and "2" |
| represents PERIPHERAL. |
| - power : Should be "50". This signifies the controller can supply upto |
| 100mA when operating in host mode. |
| |
| SOC specific device node entry |
| usb_otg_hs: usb_otg_hs@4a0ab000 { |
| compatible = "ti,omap4-musb"; |
| ti,hwmods = "usb_otg_hs"; |
| multipoint = <1>; |
| num_eps = <16>; |
| ram_bits = <12>; |
| }; |
| |
| Board specific device node entry |
| &usb_otg_hs { |
| interface_type = <1>; |
| mode = <3>; |
| power = <50>; |
| }; |
