| /* SPDX-License-Identifier: (GPL-2.0+ OR MIT) */ |
| /* |
| * arch/arm/cpu/armv8/gxb/firmware/bl21/serial.h |
| * |
| * Copyright (C) 2020 Amlogic, Inc. All rights reserved. |
| * |
| */ |
| |
| #ifndef __SERIAL_H__ |
| #define __SERIAL_H__ |
| |
| |
| //#define P_AO_UART_WFIFO (0xc81004c0) |
| //#define P_AO_RTI_PIN_MUX_REG (0xc8100014) |
| #define UART_WFIFO (0<<2) |
| #define UART_RFIFO (1<<2) |
| #define UART_CONTROL (2<<2) |
| #define UART_STATUS (3<<2) |
| #define UART_MISC (4<<2) |
| #define UART_PORT_CONS AO_UART_WFIFO |
| //#define UART_CLK_SRC CLK_CLK81 |
| |
| #define P_UART(uart_base,reg) (uart_base+reg) |
| #define P_UART_WFIFO(uart_base) P_UART(uart_base,UART_WFIFO) |
| #define P_UART_RFIFO(uart_base) P_UART(uart_base,UART_RFIFO) |
| |
| #define P_UART_CONTROL(uart_base) P_UART(uart_base,UART_CONTROL) |
| #define UART_CNTL_MASK_BAUD_RATE (0xfff) |
| #define UART_CNTL_MASK_TX_EN (1<<12) |
| #define UART_CNTL_MASK_RX_EN (1<<13) |
| #define UART_CNTL_MASK_2WIRE (1<<15) |
| #define UART_CNTL_MASK_STP_BITS (3<<16) |
| #define UART_CNTL_MASK_STP_1BIT (0<<16) |
| #define UART_CNTL_MASK_STP_2BIT (1<<16) |
| #define UART_CNTL_MASK_PRTY_EVEN (0<<18) |
| #define UART_CNTL_MASK_PRTY_ODD (1<<18) |
| #define UART_CNTL_MASK_PRTY_TYPE (1<<18) |
| #define UART_CNTL_MASK_PRTY_EN (1<<19) |
| #define UART_CNTL_MASK_CHAR_LEN (3<<20) |
| #define UART_CNTL_MASK_CHAR_8BIT (0<<20) |
| #define UART_CNTL_MASK_CHAR_7BIT (1<<20) |
| #define UART_CNTL_MASK_CHAR_6BIT (2<<20) |
| #define UART_CNTL_MASK_CHAR_5BIT (3<<20) |
| #define UART_CNTL_MASK_RST_TX (1<<22) |
| #define UART_CNTL_MASK_RST_RX (1<<23) |
| #define UART_CNTL_MASK_CLR_ERR (1<<24) |
| #define UART_CNTL_MASK_INV_RX (1<<25) |
| #define UART_CNTL_MASK_INV_TX (1<<26) |
| #define UART_CNTL_MASK_RINT_EN (1<<27) |
| #define UART_CNTL_MASK_TINT_EN (1<<28) |
| #define UART_CNTL_MASK_INV_CTS (1<<29) |
| #define UART_CNTL_MASK_MASK_ERR (1<<30) |
| #define UART_CNTL_MASK_INV_RTS (1<<31) |
| #define P_UART_STATUS(uart_base) P_UART(uart_base,UART_STATUS ) |
| #define UART_STAT_MASK_RFIFO_CNT (0x3f<<0) |
| #define UART_STAT_MASK_TFIFO_CNT (0x3f<<8) |
| #define UART_STAT_MASK_PRTY_ERR (1<<16) |
| #define UART_STAT_MASK_FRAM_ERR (1<<17) |
| #define UART_STAT_MASK_WFULL_ERR (1<<18) |
| #define UART_STAT_MASK_RFIFO_FULL (1<<19) |
| #define UART_STAT_MASK_RFIFO_EMPTY (1<<20) |
| #define UART_STAT_MASK_TFIFO_FULL (1<<21) |
| #define UART_STAT_MASK_TFIFO_EMPTY (1<<22) |
| #define P_UART_MISC(uart_base) P_UART(uart_base,UART_MISC) |
| |
| void serial_init(unsigned set); |
| int serial_putc(int c); |
| int serial_getc(void); |
| int serial_puts(const char *s); |
| void serial_put_hex(unsigned long data,unsigned int bitlen); |
| void serial_put_dec(unsigned long data); |
| |
| #endif /* __SERIAL_H__ */ |