| ============================================================================= | |
| List of methods in project: RTOSDemo | |
| THIS TEXT DESCRIPTION IS GENERATED BY THE TOOL. DO NOT MODIFY IT. | |
| ============================================================================= | |
| Module "Byte1" (bean ByteIO) | |
| Byte1_PutBit -Put the specified value to the specified bit/pin of the Input/Output bean. If direction is [input] saves the | |
| value to a memory or a register, this value will be written to the pin after switching to the output mode - | |
| using [SetDir(TRUE)]. If direction is [output] writes the value to the pin. | |
| Byte1_NegBit -Negate (invert) the specified bit of the Input/Output bean. It is the same as [PutBit(Bit,!GetBit(Bit))]. | |
| Module "TickTimer" (bean TimerInt) | |
| TickTimer_Enable -Enable the bean - it starts the timer. Events may be generated ("DisableEvent"/"EnableEvent"). | |
| TickTimer_SetFreqHz -This method sets the new frequency of the generated events. The frequency is expressed in [Hz] as a | |
| 16-bit unsigned integer number. This method is available only if runtime setting type 'from interval' is | |
| selected in the <Timing dialog box> in Runtime setting area. | |
| Module "ButtonInterrupt" (bean ExtInt) | |
| ButtonInterrupt_Enable -Enable the bean - the external events are accepted. | |
| Module "Cpu" (bean MC9S12C32_80) | |
| Cpu_EnableInt -Enable maskable interrupts | |
| Cpu_DisableInt -Disable maskable interrupts | |
| Cpu_SetWaitMode -Set low power mode - Wait mode. | |
| For more information about the wait mode see documentation of this CPU. | |
| Release from Wait mode: Reset or interrupt | |
| Cpu_SetStopMode -Set low power mode - Stop mode. | |
| For more information about the stop mode see documentation of this CPU. | |
| ============================================================================= |