/******************************************************************************
*  Filename:       ccfgread_doc.h
*  Revised:        2016-03-30 13:03:59 +0200 (Wed, 30 Mar 2016)
*  Revision:       45971
*
*  Copyright (c) 2015 - 2016, Texas Instruments Incorporated
*  All rights reserved.
*
*  Redistribution and use in source and binary forms, with or without
*  modification, are permitted provided that the following conditions are met:
*
*  1) Redistributions of source code must retain the above copyright notice,
*     this list of conditions and the following disclaimer.
*
*  2) Redistributions in binary form must reproduce the above copyright notice,
*     this list of conditions and the following disclaimer in the documentation
*     and/or other materials provided with the distribution.
*
*  3) Neither the name of the ORGANIZATION nor the names of its contributors may
*     be used to endorse or promote products derived from this software without
*     specific prior written permission.
*
*  THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS"
*  AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
*  IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
*  ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE
*  LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
*  CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
*  SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
*  INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
*  CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
*  ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
*  POSSIBILITY OF SUCH DAMAGE.
*
******************************************************************************/
//! \addtogroup ccfgread_api
//! @{
//! \section sec_ccfgread Introduction
//!
//! The values of customer configuration (CCFG) settings in flash are determined by ccfg.c and typically
//! a user application does not need to read these CCFG values as they are used mainly during ROM boot
//! and device trimming. However, a subset of the CCFG settings need to be read by application
//! code thus DriverLib provides this API to allow easy read access to these specific settings.
//!
//! The remaining settings not accessible through this API can of course be read directly at the CCFG
//! addresses in the flash (starting at CCFG_BASE) using the HWREG macro and the provided defines.
//! CCFG settings are documented as part of the register descriptions in the CPU memory map.
//!
//! \note CCFG settings are located in flash and should be considered read-only from an application
//! point-of-view.
//! @}