| /****************************************************************************** |
| * Filename: ieee_mailbox.h |
| * Revised: $ $ |
| * Revision: $ $ |
| * |
| * Description: Definitions for IEEE 802.15.4 interface |
| * |
| * Copyright (c) 2015 - 2016, Texas Instruments Incorporated |
| * All rights reserved. |
| * |
| * Redistribution and use in source and binary forms, with or without |
| * modification, are permitted provided that the following conditions are met: |
| * |
| * 1) Redistributions of source code must retain the above copyright notice, |
| * this list of conditions and the following disclaimer. |
| * |
| * 2) Redistributions in binary form must reproduce the above copyright notice, |
| * this list of conditions and the following disclaimer in the documentation |
| * and/or other materials provided with the distribution. |
| * |
| * 3) Neither the name of the ORGANIZATION nor the names of its contributors may |
| * be used to endorse or promote products derived from this software without |
| * specific prior written permission. |
| * |
| * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" |
| * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE |
| * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE |
| * ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE |
| * LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR |
| * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF |
| * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS |
| * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN |
| * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) |
| * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE |
| * POSSIBILITY OF SUCH DAMAGE. |
| * |
| ******************************************************************************/ |
| |
| #ifndef _IEEE_MAILBOX_H |
| #define _IEEE_MAILBOX_H |
| |
| /// \name Radio operation status |
| ///@{ |
| /// \name Operation not finished |
| ///@{ |
| #define IEEE_SUSPENDED 0x2001 ///< Operation suspended |
| ///@} |
| /// \name Operation finished normally |
| ///@{ |
| #define IEEE_DONE_OK 0x2400 ///< Operation ended normally |
| #define IEEE_DONE_BUSY 0x2401 ///< CSMA-CA operation ended with failure |
| #define IEEE_DONE_STOPPED 0x2402 ///< Operation stopped after stop command |
| #define IEEE_DONE_ACK 0x2403 ///< ACK packet received with pending data bit cleared |
| #define IEEE_DONE_ACKPEND 0x2404 ///< ACK packet received with pending data bit set |
| #define IEEE_DONE_TIMEOUT 0x2405 ///< Operation ended due to timeout |
| #define IEEE_DONE_BGEND 0x2406 ///< FG operation ended because necessary background level |
| ///< operation ended |
| #define IEEE_DONE_ABORT 0x2407 ///< Operation aborted by command |
| ///@} |
| /// \name Operation finished with error |
| ///@{ |
| #define IEEE_ERROR_PAR 0x2800 ///< Illegal parameter |
| #define IEEE_ERROR_NO_SETUP 0x2801 ///< Operation using Rx or Tx attemted when not in 15.4 mode |
| #define IEEE_ERROR_NO_FS 0x2802 ///< Operation using Rx or Tx attemted without frequency synth configured |
| #define IEEE_ERROR_SYNTH_PROG 0x2803 ///< Synthesizer programming failed to complete on time |
| #define IEEE_ERROR_RXOVF 0x2804 ///< Receiver overflowed during operation |
| #define IEEE_ERROR_TXUNF 0x2805 ///< Transmitter underflowed during operation |
| ///@} |
| ///@} |
| |
| #endif /* _IEEE_MAILBOX_H */ |