blob: 92954e1c907bf9dddb64aa433aa6374cd324205a [file] [log] [blame]
/*
* Startup Code for MIPS64 CPU-core
*
* Copyright (c) 2003 Wolfgang Denk <wd@denx.de>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <asm-offsets.h>
#include <config.h>
#include <asm/regdef.h>
#include <asm/mipsregs.h>
#ifndef CONFIG_SYS_MIPS_CACHE_MODE
#define CONFIG_SYS_MIPS_CACHE_MODE CONF_CM_CACHABLE_NONCOHERENT
#endif
#ifdef CONFIG_SYS_LITTLE_ENDIAN
#define MIPS64_R_INFO(ssym, r_type3, r_type2, r_type) \
(((r_type) << 24) | ((r_type2) << 16) | ((r_type3) << 8) | (ssym))
#else
#define MIPS64_R_INFO(ssym, r_type3, r_type2, r_type) \
((r_type) | ((r_type2) << 8) | ((r_type3) << 16) | (ssym) << 24)
#endif
/*
* For the moment disable interrupts, mark the kernel mode and
* set ST0_KX so that the CPU does not spit fire when using
* 64-bit addresses.
*/
.macro setup_c0_status set clr
.set push
mfc0 t0, CP0_STATUS
or t0, ST0_CU0 | \set | 0x1f | \clr
xor t0, 0x1f | \clr
mtc0 t0, CP0_STATUS
.set noreorder
sll zero, 3 # ehb
.set pop
.endm
.set noreorder
.globl _start
.text
_start:
/* U-boot entry point */
b reset
nop
.org 0x200
/* TLB refill, 32 bit task */
1: b 1b
nop
.org 0x280
/* XTLB refill, 64 bit task */
1: b 1b
nop
.org 0x300
/* Cache error exception */
1: b 1b
nop
.org 0x380
/* General exception */
1: b 1b
nop
.org 0x400
/* Catch interrupt exceptions */
1: b 1b
nop
.org 0x480
/* EJTAG debug exception */
1: b 1b
nop
.align 4
reset:
/* Clear watch registers */
dmtc0 zero, CP0_WATCHLO
dmtc0 zero, CP0_WATCHHI
/* WP(Watch Pending), SW0/1 should be cleared */
mtc0 zero, CP0_CAUSE
setup_c0_status ST0_KX 0
/* Init Timer */
mtc0 zero, CP0_COUNT
mtc0 zero, CP0_COMPARE
#ifndef CONFIG_SKIP_LOWLEVEL_INIT
/* CONFIG0 register */
dli t0, CONF_CM_UNCACHED
mtc0 t0, CP0_CONFIG
#endif
/*
* Initialize $gp, force 8 byte alignment of bal instruction to forbid
* the compiler to put nop's between bal and _gp. This is required to
* keep _gp and ra aligned to 8 byte.
*/
.align 3
bal 1f
nop
.dword _gp
1:
ld gp, 0(ra)
#ifndef CONFIG_SKIP_LOWLEVEL_INIT
/* Initialize any external memory */
dla t9, lowlevel_init
jalr t9
nop
/* Initialize caches... */
dla t9, mips_cache_reset
jalr t9
nop
/* ... and enable them */
dli t0, CONFIG_SYS_MIPS_CACHE_MODE
mtc0 t0, CP0_CONFIG
#endif
/* Set up temporary stack */
dli sp, CONFIG_SYS_SDRAM_BASE + CONFIG_SYS_INIT_SP_OFFSET
dla t9, board_init_f
jr t9
nop
/*
* void relocate_code (addr_sp, gd, addr_moni)
*
* This "function" does not return, instead it continues in RAM
* after relocating the monitor code.
*
* a0 = addr_sp
* a1 = gd
* a2 = destination address
*/
.globl relocate_code
.ent relocate_code
relocate_code:
move sp, a0 # set new stack pointer
move s0, a1 # save gd in s0
move s2, a2 # save destination address in s2
dli t0, CONFIG_SYS_MONITOR_BASE
dsub s1, s2, t0 # s1 <-- relocation offset
dla t3, in_ram
ld t2, -24(t3) # t2 <-- __image_copy_end
move t1, a2
dadd gp, s1 # adjust gp
/*
* t0 = source address
* t1 = target address
* t2 = source end address
*/
1:
lw t3, 0(t0)
sw t3, 0(t1)
daddu t0, 4
blt t0, t2, 1b
daddu t1, 4
/* If caches were enabled, we would have to flush them here. */
dsub a1, t1, s2 # a1 <-- size
dla t9, flush_cache
jalr t9
move a0, s2 # a0 <-- destination address
/* Jump to where we've relocated ourselves */
daddi t0, s2, in_ram - _start
jr t0
nop
.dword __rel_dyn_end
.dword __rel_dyn_start
.dword __image_copy_end
.dword _GLOBAL_OFFSET_TABLE_
.dword num_got_entries
in_ram:
/*
* Now we want to update GOT.
*
* GOT[0] is reserved. GOT[1] is also reserved for the dynamic object
* generated by GNU ld. Skip these reserved entries from relocation.
*/
ld t3, -8(t0) # t3 <-- num_got_entries
ld t8, -16(t0) # t8 <-- _GLOBAL_OFFSET_TABLE_
dadd t8, s1 # t8 now holds relocated _G_O_T_
daddi t8, t8, 16 # skipping first two entries
dli t2, 2
1:
ld t1, 0(t8)
beqz t1, 2f
dadd t1, s1
sd t1, 0(t8)
2:
daddi t2, 1
blt t2, t3, 1b
daddi t8, 8
/* Update dynamic relocations */
ld t1, -32(t0) # t1 <-- __rel_dyn_start
ld t2, -40(t0) # t2 <-- __rel_dyn_end
b 2f # skip first reserved entry
daddi t1, 16
1:
lw t8, -4(t1) # t8 <-- relocation info
dli t3, MIPS64_R_INFO(0x00, 0x00, 0x12, 0x03)
bne t8, t3, 2f # skip non R_MIPS_REL32 entries
nop
ld t3, -16(t1) # t3 <-- location to fix up in FLASH
ld t8, 0(t3) # t8 <-- original pointer
dadd t8, s1 # t8 <-- adjusted pointer
dadd t3, s1 # t3 <-- location to fix up in RAM
sd t8, 0(t3)
2:
blt t1, t2, 1b
daddi t1, 16 # each rel.dyn entry is 16 bytes
/*
* Clear BSS
*
* GOT is now relocated. Thus __bss_start and __bss_end can be
* accessed directly via $gp.
*/
dla t1, __bss_start # t1 <-- __bss_start
dla t2, __bss_end # t2 <-- __bss_end
1:
sd zero, 0(t1)
blt t1, t2, 1b
daddi t1, 8
move a0, s0 # a0 <-- gd
dla t9, board_init_r
jr t9
move a1, s2
.end relocate_code