| /* |
| * Copyright (C) 2012-2014 Freescale Semiconductor, Inc. |
| * |
| * Configuration settings for the Freescale i.MX6Q SabreAuto board. |
| * |
| * SPDX-License-Identifier: GPL-2.0+ |
| */ |
| |
| #ifndef __MX6QSABREAUTO_CONFIG_H |
| #define __MX6QSABREAUTO_CONFIG_H |
| |
| #define CONFIG_MACH_TYPE 3529 |
| #define CONFIG_MXC_UART_BASE UART4_BASE |
| #define CONFIG_CONSOLE_DEV "ttymxc3" |
| #define CONFIG_MMCROOT "/dev/mmcblk2p2" /* SDHC3 */ |
| |
| #define CONFIG_SYS_USE_NAND |
| |
| #include "mx6sabre_common.h" |
| #include <asm/imx-common/gpio.h> |
| |
| #undef CONFIG_MFG_NAND_PARTITION |
| #ifdef CONFIG_SYS_BOOT_NAND |
| #define CONFIG_MFG_NAND_PARTITION "mtdparts=8000000.nor:1m(boot),-(rootfs)\\\\;gpmi-nand:64m(boot),16m(kernel),16m(dtb),-(rootfs) " |
| #else |
| #define CONFIG_MFG_NAND_PARTITION "" |
| #endif |
| |
| /*Since the pin conflicts on EIM D18, disable the USB host if the NOR flash is enabled */ |
| #if !defined(CONFIG_SYS_USE_SPINOR) && !defined(CONFIG_SYS_USE_EIMNOR) |
| /* USB Configs */ |
| #define CONFIG_CMD_USB |
| #define CONFIG_USB_EHCI |
| #define CONFIG_USB_EHCI_MX6 |
| #define CONFIG_USB_STORAGE |
| #define CONFIG_EHCI_HCD_INIT_AFTER_RESET |
| #define CONFIG_USB_HOST_ETHER |
| #define CONFIG_USB_ETHER_ASIX |
| #define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW) |
| #define CONFIG_MXC_USB_FLAGS 0 |
| #define CONFIG_USB_MAX_CONTROLLER_COUNT 2 /* Enabled USB controller number */ |
| |
| /* MAX7310 configs*/ |
| #define CONFIG_MAX7310_IOEXP |
| #define CONFIG_IOEXP_DEVICES_NUM 3 |
| #define CONFIG_IOEXP_DEV_PINS_NUM 8 |
| #endif |
| |
| #define CONFIG_SYS_FSL_USDHC_NUM 2 |
| #define CONFIG_SYS_MMC_ENV_DEV 1 /* SDHC3 */ |
| #define CONFIG_SYS_MMC_ENV_PART 0 /* user partition */ |
| |
| #ifdef CONFIG_SYS_USE_SPINOR |
| #define CONFIG_SF_DEFAULT_CS (1|(IMX_GPIO_NR(3, 19)<<8)) |
| #endif |
| |
| #endif /* __MX6QSABREAUTO_CONFIG_H */ |
