| .TH I2C-STUB-FROM-DUMP 8 "April 2008" |
| .SH NAME |
| i2c-stub-from-dump \- feed i2c-stub with a dump file |
| |
| .SH SYNOPSIS |
| .B i2c-stub-from-dump |
| .I address |
| .I dump-file |
| |
| .SH DESCRIPTION |
| i2c-stub-from-dump is a small helper script for the i2c-stub kernel driver. |
| It lets you setup a fake I2C chip on the i2c-stub bus based on a dump of |
| the chip you want to emulate. |
| |
| i2c-stub-from-dump requires i2cdetect and i2cset to be installed and |
| reachable through the user's PATH. The former is used to find out the i2c-stub |
| bus number, while the latter is used to write to the fake I2C chip. |
| |
| .SH EXAMPLE |
| You have an I2C chip on system A. You would like to do some development on its |
| driver on system B. Here are the few steps you have to follow. |
| |
| On system A, use i2cdump to capture a dump from the chip. Assuming that the |
| chip in question lives at address 0x4c on I2C bus 0, you would run: |
| |
| i2cdump -y 0 0x4c b > chip.dump |
| |
| Adjust the bus number and chip address for your case. i2cdetect can help |
| you find out their values. If the device uses word (16-bit) register |
| access instead of the traditional byte (8-bit) access, use mode \fBw\fR |
| instead of \fBb\fR. |
| |
| Copy the dump file to system B. |
| |
| On system B, run: |
| |
| i2c-stub-from-dump 0x4c chip.dump |
| |
| This will load the required i2c-dev and i2c-stub kernel drivers if needed, |
| then write all the register values to the emulated I2C chip at address 0x4c. |
| Again, adjust the address as needed. |
| |
| .SH LIMITATIONS |
| There are some limitations to the kind of devices that can be handled: |
| .IP \(bu |
| Device must not have banks (as most Winbond devices do). |
| |
| .SH SEE ALSO |
| i2cdump(8), i2cdetect(8), i2cset(8) |
| |
| .SH AUTHOR |
| Jean Delvare |