/*
 * Definitions for ioctls to access DHD iovars.
 * Based on wlioctl.h (for Broadcom 802.11abg driver).
 * (Moves towards generic ioctls for BCM drivers/iovars.)
 *
 * Definitions subject to change without notice.
 *
 * $Copyright Open Broadcom Corporation$
 *
 * $Id: dhdioctl.h 454792 2014-02-11 20:40:19Z $
 */

#ifndef _dhdioctl_h_
#define	_dhdioctl_h_

#include <typedefs.h>


/* require default structure packing */
#define BWL_DEFAULT_PACKING
#include <packed_section_start.h>


/* Linux network driver ioctl encoding */
typedef struct dhd_ioctl {
	uint cmd;	/* common ioctl definition */
	void *buf;	/* pointer to user buffer */
	uint len;	/* length of user buffer */
	bool set;	/* get or set request (optional) */
	uint used;	/* bytes read or written (optional) */
	uint needed;	/* bytes needed (optional) */
	uint driver;	/* to identify target driver */
} dhd_ioctl_t;

/* Underlying BUS definition */
enum {
	BUS_TYPE_USB = 0, /* for USB dongles */
	BUS_TYPE_SDIO, /* for SDIO dongles */
	BUS_TYPE_PCIE /* for PCIE dongles */
};

/* per-driver magic numbers */
#define DHD_IOCTL_MAGIC		0x00444944

/* bump this number if you change the ioctl interface */
#define DHD_IOCTL_VERSION	1

#define	DHD_IOCTL_MAXLEN	8192		/* max length ioctl buffer required */
#define	DHD_IOCTL_SMLEN		256		/* "small" length ioctl buffer required */

/* common ioctl definitions */
#define DHD_GET_MAGIC				0
#define DHD_GET_VERSION				1
#define DHD_GET_VAR				2
#define DHD_SET_VAR				3

/* message levels */
#define DHD_ERROR_VAL	0x0001
#define DHD_TRACE_VAL	0x0002
#define DHD_INFO_VAL	0x0004
#define DHD_DATA_VAL	0x0008
#define DHD_CTL_VAL	0x0010
#define DHD_TIMER_VAL	0x0020
#define DHD_HDRS_VAL	0x0040
#define DHD_BYTES_VAL	0x0080
#define DHD_INTR_VAL	0x0100
#define DHD_LOG_VAL	0x0200
#define DHD_GLOM_VAL	0x0400
#define DHD_EVENT_VAL	0x0800
#define DHD_BTA_VAL	0x1000
#if 0 && (NDISVER >= 0x0630) && 1
#define DHD_SCAN_VAL	0x2000
#else
#define DHD_ISCAN_VAL	0x2000
#endif
#define DHD_ARPOE_VAL	0x4000
#define DHD_REORDER_VAL	0x8000
#define DHD_WL_VAL		0x10000
#define DHD_NOCHECKDIED_VAL		0x20000 /* UTF WAR */
#define DHD_WL_VAL2		0x40000
#define DHD_PNO_VAL		0x80000

#ifdef SDTEST
/* For pktgen iovar */
typedef struct dhd_pktgen {
	uint version;		/* To allow structure change tracking */
	uint freq;		/* Max ticks between tx/rx attempts */
	uint count;		/* Test packets to send/rcv each attempt */
	uint print;		/* Print counts every <print> attempts */
	uint total;		/* Total packets (or bursts) */
	uint minlen;		/* Minimum length of packets to send */
	uint maxlen;		/* Maximum length of packets to send */
	uint numsent;		/* Count of test packets sent */
	uint numrcvd;		/* Count of test packets received */
	uint numfail;		/* Count of test send failures */
	uint mode;		/* Test mode (type of test packets) */
	uint stop;		/* Stop after this many tx failures */
} dhd_pktgen_t;

/* Version in case structure changes */
#define DHD_PKTGEN_VERSION 2

/* Type of test packets to use */
#define DHD_PKTGEN_ECHO		1 /* Send echo requests */
#define DHD_PKTGEN_SEND 	2 /* Send discard packets */
#define DHD_PKTGEN_RXBURST	3 /* Request dongle send N packets */
#define DHD_PKTGEN_RECV		4 /* Continuous rx from continuous tx dongle */
#endif /* SDTEST */

/* Enter idle immediately (no timeout) */
#define DHD_IDLE_IMMEDIATE	(-1)

/* Values for idleclock iovar: other values are the sd_divisor to use when idle */
#define DHD_IDLE_ACTIVE	0	/* Do not request any SD clock change when idle */
#define DHD_IDLE_STOP   (-1)	/* Request SD clock be stopped (and use SD1 mode) */


/* require default structure packing */
#include <packed_section_end.h>

#endif /* _dhdioctl_h_ */