blob: b967544590e804c413063cfbd4c1d56bee6f486b [file] [log] [blame]
* Freescale Inter IC (I2C) and High Speed Inter IC (HS-I2C) for i.MX
Required properties:
- compatible :
- "fsl,imx1-i2c" for I2C compatible with the one integrated on i.MX1 SoC
- "fsl,imx21-i2c" for I2C compatible with the one integrated on i.MX21 SoC
- "fsl,vf610-i2c" for I2C compatible with the one integrated on Vybrid vf610 SoC
- reg : Should contain I2C/HS-I2C registers location and length
- interrupts : Should contain I2C/HS-I2C interrupt
- clocks : Should contain the I2C/HS-I2C clock specifier
Optional properties:
- clock-frequency : Constains desired I2C/HS-I2C bus clock frequency in Hz.
The absence of the property indicates the default frequency 100 kHz.
- dmas: A list of two dma specifiers, one for each entry in dma-names.
- dma-names: should contain "tx" and "rx".
- scl-gpios: specify the gpio related to SCL pin
- sda-gpios: specify the gpio related to SDA pin
- pinctrl: add extra pinctrl to configure i2c pins to gpio function for i2c
bus recovery, call it "gpio" state
Examples:
i2c@83fc4000 { /* I2C2 on i.MX51 */
compatible = "fsl,imx51-i2c", "fsl,imx21-i2c";
reg = <0x83fc4000 0x4000>;
interrupts = <63>;
};
i2c@70038000 { /* HS-I2C on i.MX51 */
compatible = "fsl,imx51-i2c", "fsl,imx21-i2c";
reg = <0x70038000 0x4000>;
interrupts = <64>;
clock-frequency = <400000>;
};
i2c0: i2c@40066000 { /* i2c0 on vf610 */
compatible = "fsl,vf610-i2c";
reg = <0x40066000 0x1000>;
interrupts =<0 71 0x04>;
dmas = <&edma0 0 50>,
<&edma0 0 51>;
dma-names = "rx","tx";
pinctrl-names = "default", "gpio";
pinctrl-0 = <&pinctrl_i2c1>;
pinctrl-1 = <&pinctrl_i2c1_gpio>;
scl-gpios = <&gpio5 26 GPIO_ACTIVE_HIGH>;
sda-gpios = <&gpio5 27 GPIO_ACTIVE_HIGH>;
};