* Renesas Clock Pulse Generator / Module Standby and Software Reset

On Renesas ARM SoCs (SH/R-Mobile, R-Car, RZ), the CPG (Clock Pulse Generator)
and MSSR (Module Standby and Software Reset) blocks are intimately connected,
and share the same register block.

They provide the following functionalities:
  - The CPG block generates various core clocks,
  - The MSSR block provides two functions:
      1. Module Standby, providing a Clock Domain to control the clock supply
	 to individual SoC devices,
      2. Reset Control, to perform a software reset of individual SoC devices.

Required Properties:
  - compatible: Must be one of:
      - "renesas,r8a7795-cpg-mssr" for the r8a7795 SoC (R-Car H3)
      - "renesas,r8a7796-cpg-mssr" for the r8a7796 SoC (R-Car M3-W)

  - reg: Base address and length of the memory resource used by the CPG/MSSR
    block

  - clocks: References to external parent clocks, one entry for each entry in
    clock-names
  - clock-names: List of external parent clock names. Valid names are:
      - "extal" (r8a7795, r8a7796)
      - "extalr" (r8a7795, r8a7796)

  - #clock-cells: Must be 2
      - For CPG core clocks, the two clock specifier cells must be "CPG_CORE"
	and a core clock reference, as defined in
	<dt-bindings/clock/*-cpg-mssr.h>.
      - For module clocks, the two clock specifier cells must be "CPG_MOD" and
	a module number, as defined in the datasheet.

  - #power-domain-cells: Must be 0
      - SoC devices that are part of the CPG/MSSR Clock Domain and can be
	power-managed through Module Standby should refer to the CPG device
	node in their "power-domains" property, as documented by the generic PM
	Domain bindings in
	Documentation/devicetree/bindings/power/power_domain.txt.


Examples
--------

  - CPG device node:

	cpg: clock-controller@e6150000 {
		compatible = "renesas,r8a7795-cpg-mssr";
		reg = <0 0xe6150000 0 0x1000>;
		clocks = <&extal_clk>, <&extalr_clk>;
		clock-names = "extal", "extalr";
		#clock-cells = <2>;
		#power-domain-cells = <0>;
	};


  - CPG/MSSR Clock Domain member device node:

	scif2: serial@e6e88000 {
		compatible = "renesas,scif-r8a7795", "renesas,scif";
		reg = <0 0xe6e88000 0 64>;
		interrupts = <GIC_SPI 164 IRQ_TYPE_LEVEL_HIGH>;
		clocks = <&cpg CPG_MOD 310>;
		clock-names = "fck";
		dmas = <&dmac1 0x13>, <&dmac1 0x12>;
		dma-names = "tx", "rx";
		power-domains = <&cpg>;
		status = "disabled";
	};