| Raydium RM67171 OLED LCD panel with MIPI-DSI protocol |
| |
| Required properties: |
| - compatible: "raydium,rm67191" |
| - reg: virtual channel for MIPI-DSI protocol |
| must be <0> |
| - dsi-lanes: number of DSI lanes to be used |
| must be <3> or <4> |
| - port: input port node with endpoint definition as |
| defined in Documentation/devicetree/bindings/graph.txt; |
| the input port should be connected to a MIPI-DSI device |
| driver |
| |
| Optional properties: |
| - reset-gpio: a GPIO spec for the RST_B GPIO pin |
| - display-timings: timings for the connected panel according to [1] |
| - pinctrl-0 phandle to the pin settings for the reset pin |
| - panel-width-mm: physical panel width [mm] |
| - panel-height-mm: physical panel height [mm] |
| |
| [1]: Documentation/devicetree/bindings/display/display-timing.txt |
| |
| Example: |
| |
| panel@0 { |
| compatible = "raydium,rm67191"; |
| reg = <0>; |
| pinctrl-0 = <&pinctrl_mipi_dsi_0_1_en>; |
| reset-gpio = <&gpio1 7 GPIO_ACTIVE_HIGH>; |
| dsi-lanes = <4>; |
| panel-width-mm = <68>; |
| panel-height-mm = <121>; |
| display-timings { |
| timing { |
| clock-frequency = <132000000>; |
| hactive = <1080>; |
| vactive = <1920>; |
| hback-porch = <11>; |
| hfront-porch = <4>; |
| vback-porch = <48>; |
| vfront-porch = <20>; |
| hsync-len = <5>; |
| vsync-len = <12>; |
| hsync-active = <0>; |
| vsync-active = <0>; |
| de-active = <0>; |
| pixelclk-active = <0>; |
| }; |
| }; |
| port { |
| panel1_in: endpoint { |
| remote-endpoint = <&mipi1_out>; |
| }; |
| }; |
| }; |