blob: 76df9173825a00e39cca99a9a8c35bc51f2b57b8 [file] [log] [blame]
* Marvell International Ltd. NCI NFC Controller
Required properties:
- compatible: Should be:
- "marvell,nfc-uart" or "mrvl,nfc-uart" for UART devices
- "marvell,nfc-i2c" for I2C devices
- "marvell,nfc-spi" for SPI devices
Optional SoC specific properties:
- pinctrl-names: Contains only one value - "default".
- pintctrl-0: Specifies the pin control groups used for this controller.
- reset-n-io: Output GPIO pin used to reset the chip (active low).
- hci-muxed: Specifies that the chip is muxing NCI over HCI frames.
Optional UART-based chip specific properties:
- flow-control: Specifies that the chip is using RTS/CTS.
- break-control: Specifies that the chip needs specific break management.
Optional I2C-based chip specific properties:
- i2c-int-falling: Specifies that the chip read event shall be trigged on
falling edge.
- i2c-int-rising: Specifies that the chip read event shall be trigged on
rising edge.
Example (for ARM-based BeagleBoard Black with 88W8887 on UART5):
&uart5 {
status = "okay";
nfcmrvluart: nfcmrvluart@5 {
compatible = "marvell,nfc-uart";
reset-n-io = <&gpio3 16 0>;
hci-muxed;
flow-control;
}
};
Example (for ARM-based BeagleBoard Black with 88W8887 on I2C1):
&i2c1 {
status = "okay";
clock-frequency = <400000>;
nfcmrvli2c0: i2c@1 {
compatible = "marvell,nfc-i2c";
reg = <0x8>;
/* I2C INT configuration */
interrupt-parent = <&gpio3>;
interrupts = <21 0>;
/* I2C INT trigger configuration */
i2c-int-rising;
/* Reset IO */
reset-n-io = <&gpio3 19 0>;
};
};
Example (for ARM-based BeagleBoard Black on SPI0):
&spi0 {
mrvlnfcspi0: spi@0 {
compatible = "marvell,nfc-spi";
reg = <0>;
/* SPI Bus configuration */
spi-max-frequency = <3000000>;
spi-cpha;
spi-cpol;
/* SPI INT configuration */
interrupt-parent = <&gpio1>;
interrupts = <17 0>;
/* Reset IO */
reset-n-io = <&gpio3 19 0>;
};
};