blob: 0dded64d89d3bf198f3e2ab2f6daf9a92b414728 [file] [log] [blame]
Binding for Maxim MAX77686 regulators
This is a part of the device tree bindings of MAX77686 multi-function device.
More information can be found in ../mfd/max77686.txt file.
The MAX77686 PMIC has 9 high-efficiency Buck and 26 Low-DropOut (LDO)
regulators that can be controlled over I2C.
Following properties should be present in main device node of the MFD chip.
Optional node:
- voltage-regulators : The regulators of max77686 have to be instantiated
under subnode named "voltage-regulators" using the following format.
regulator_name {
regulator-compatible = LDOn/BUCKn
standard regulator constraints....
};
refer Documentation/devicetree/bindings/regulator/regulator.txt
The regulator node's name should be initialized with a string
to get matched with their hardware counterparts as follow:
-LDOn : for LDOs, where n can lie in range 1 to 26.
example: LDO1, LDO2, LDO26.
-BUCKn : for BUCKs, where n can lie in range 1 to 9.
example: BUCK1, BUCK5, BUCK9.
Regulators which can be turned off during system suspend:
-LDOn : 2, 6-8, 10-12, 14-16,
-BUCKn : 1-4.
Use standard regulator bindings for it ('regulator-off-in-suspend').
LDO20, LDO21, LDO22, BUCK8 and BUCK9 can be configured to GPIO enable
control. To turn this feature on this property must be added to the regulator
sub-node:
- maxim,ena-gpios : one GPIO specifier enable control (the gpio
flags are actually ignored and always
ACTIVE_HIGH is used)
Example:
max77686: pmic@09 {
compatible = "maxim,max77686";
interrupt-parent = <&wakeup_eint>;
interrupts = <26 IRQ_TYPE_NONE>;
reg = <0x09>;
voltage-regulators {
ldo11_reg: LDO11 {
regulator-name = "vdd_ldo11";
regulator-min-microvolt = <1900000>;
regulator-max-microvolt = <1900000>;
regulator-always-on;
};
buck1_reg: BUCK1 {
regulator-name = "vdd_mif";
regulator-min-microvolt = <950000>;
regulator-max-microvolt = <1300000>;
regulator-always-on;
regulator-boot-on;
};
buck9_reg: BUCK9 {
regulator-name = "CAM_ISP_CORE_1.2V";
regulator-min-microvolt = <1000000>;
regulator-max-microvolt = <1200000>;
maxim,ena-gpios = <&gpm0 3 GPIO_ACTIVE_HIGH>;
};
};