| Oxford Semiconductor OXNAS SoC Family RESET Controller |
| ================================================ |
| |
| Please also refer to reset.txt in this directory for common reset |
| controller binding usage. |
| |
| Required properties: |
| - compatible: Should be "oxsemi,ox810se-reset" |
| - #reset-cells: 1, see below |
| |
| Parent node should have the following properties : |
| - compatible: Should be "oxsemi,ox810se-sys-ctrl", "syscon", "simple-mfd" |
| |
| For OX810SE, the indices are : |
| - 0 : ARM |
| - 1 : COPRO |
| - 2 : Reserved |
| - 3 : Reserved |
| - 4 : USBHS |
| - 5 : USBHSPHY |
| - 6 : MAC |
| - 7 : PCI |
| - 8 : DMA |
| - 9 : DPE |
| - 10 : DDR |
| - 11 : SATA |
| - 12 : SATA_LINK |
| - 13 : SATA_PHY |
| - 14 : Reserved |
| - 15 : NAND |
| - 16 : GPIO |
| - 17 : UART1 |
| - 18 : UART2 |
| - 19 : MISC |
| - 20 : I2S |
| - 21 : AHB_MON |
| - 22 : UART3 |
| - 23 : UART4 |
| - 24 : SGDMA |
| - 25 : Reserved |
| - 26 : Reserved |
| - 27 : Reserved |
| - 28 : Reserved |
| - 29 : Reserved |
| - 30 : Reserved |
| - 31 : BUS |
| |
| example: |
| |
| sys: sys-ctrl@000000 { |
| compatible = "oxsemi,ox810se-sys-ctrl", "syscon", "simple-mfd"; |
| reg = <0x000000 0x100000>; |
| |
| reset: reset-controller { |
| compatible = "oxsemi,ox810se-reset"; |
| #reset-cells = <1>; |
| }; |
| }; |
