blob: 98d1983969566a0278b4544a5a24cef3c14fe85c [file] [log] [blame]
* Marvell PXA GPIO controller
Required properties:
- compatible : Should be "intel,pxa25x-gpio", "intel,pxa26x-gpio",
"intel,pxa27x-gpio", "intel,pxa3xx-gpio",
"marvell,pxa93x-gpio", "marvell,mmp-gpio",
"marvell,mmp2-gpio" or marvell,pxa1928-gpio.
- reg : Address and length of the register set for the device
- interrupts : Should be the port interrupt shared by all gpio pins.
There're three gpio interrupts in arch-pxa, and they're gpio0,
gpio1 and gpio_mux. There're only one gpio interrupt in arch-mmp,
gpio_mux.
- interrupt-names : Should be the names of irq resources. Each interrupt
uses its own interrupt name, so there should be as many interrupt names
as referenced interrupts.
- interrupt-controller : Identifies the node as an interrupt controller.
- #interrupt-cells: Specifies the number of cells needed to encode an
interrupt source.
- gpio-controller : Marks the device node as a gpio controller.
- #gpio-cells : Should be one. It is the pin number.
Example for a MMP platform:
gpio: gpio@d4019000 {
compatible = "marvell,mmp-gpio";
reg = <0xd4019000 0x1000>;
interrupts = <49>;
interrupt-names = "gpio_mux";
gpio-controller;
#gpio-cells = <1>;
interrupt-controller;
#interrupt-cells = <1>;
};
Example for a PXA3xx platform:
gpio: gpio@40e00000 {
compatible = "intel,pxa3xx-gpio";
reg = <0x40e00000 0x10000>;
interrupt-names = "gpio0", "gpio1", "gpio_mux";
interrupts = <8 9 10>;
gpio-controller;
#gpio-cells = <0x2>;
interrupt-controller;
#interrupt-cells = <0x2>;
};
* Marvell Orion GPIO Controller
Required properties:
- compatible : Should be "marvell,orion-gpio"
- reg : Address and length of the register set for controller.
- gpio-controller : So we know this is a gpio controller.
- ngpio : How many gpios this controller has.
- interrupts : Up to 4 Interrupts for the controller.
Optional properties:
- mask-offset : For SMP Orions, offset for Nth CPU
Example:
gpio0: gpio@10100 {
compatible = "marvell,orion-gpio";
#gpio-cells = <2>;
gpio-controller;
reg = <0x10100 0x40>;
ngpio = <32>;
interrupts = <35>, <36>, <37>, <38>;
};