| Marvell 88PM800 regulator |
| |
| Required properties: |
| - compatible: "marvell,88pm800" |
| - reg: I2C slave address |
| - regulators: A node that houses a sub-node for each regulator within the |
| device. Each sub-node is identified using the node's name (or the deprecated |
| regulator-compatible property if present), with valid values listed below. |
| The content of each sub-node is defined by the standard binding for |
| regulators; see regulator.txt. |
| |
| The valid names for regulators are: |
| |
| buck1, buck2, buck3, buck4, buck5, ldo1, ldo2, ldo3, ldo4, ldo5, ldo6, ldo7, |
| ldo8, ldo9, ldo10, ldo11, ldo12, ldo13, ldo14, ldo15, ldo16, ldo17, ldo18, ldo19 |
| |
| Example: |
| |
| pmic: 88pm800@31 { |
| compatible = "marvell,88pm800"; |
| reg = <0x31>; |
| |
| regulators { |
| buck1 { |
| regulator-min-microvolt = <600000>; |
| regulator-max-microvolt = <3950000>; |
| regulator-boot-on; |
| regulator-always-on; |
| }; |
| ldo1 { |
| regulator-min-microvolt = <600000>; |
| regulator-max-microvolt = <15000000>; |
| regulator-boot-on; |
| regulator-always-on; |
| }; |
| ... |
| }; |
| }; |
