blob: ad1694b79fb7d7ef77af0a1014a9c006b731d2b1 [file] [log] [blame] [edit]
/*
*
* (c) 2009 Emcraft Systems, Ilya Yanok <yanok@emcraft.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <netdev.h>
#include <asm/arch/clock.h>
#include <asm/arch/imx-regs.h>
#include <asm/arch/sys_proto.h>
#include <asm/io.h>
#include <nand.h>
#include <power/pmic.h>
#include <fsl_pmic.h>
#include <asm/gpio.h>
#include "qong_fpga.h"
#include <watchdog.h>
#include <errno.h>
DECLARE_GLOBAL_DATA_PTR;
int dram_init(void)
{
/* dram_init must store complete ramsize in gd->ram_size */
gd->ram_size = get_ram_size((void *)CONFIG_SYS_SDRAM_BASE,
PHYS_SDRAM_1_SIZE);
return 0;
}
static void qong_fpga_reset(void)
{
gpio_set_value(QONG_FPGA_RST_PIN, 0);
udelay(30);
gpio_set_value(QONG_FPGA_RST_PIN, 1);
udelay(300);
}
int board_early_init_f(void)
{
#ifdef CONFIG_QONG_FPGA
/* CS1: FPGA/Network Controller/GPIO, 16-bit, no DTACK */
static const struct mxc_weimcs cs1 = {
/* sp wp bcd bcs psz pme sync dol cnc wsc ew wws edc */
CSCR_U(0, 0, 0, 0, 0, 0, 0, 0, 0, 10, 0, 0, 1),
/* oea oen ebwa ebwn csa ebc dsz csn psr cre wrap csen */
CSCR_L(2, 0, 0, 4, 0, 0, 5, 0, 0, 0, 0, 1),
/* ebra ebrn rwa rwn mum lah lbn lba dww dct wwu age cnc2 fce*/
CSCR_A(0, 4, 0, 2, 0, 0, 3, 0, 0, 0, 0, 0, 0, 0)
};
mxc_setup_weimcs(1, &cs1);
/* setup pins for FPGA */
mx31_gpio_mux(IOMUX_MODE(0x76, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(0x7e, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(0x91, MUX_CTL_OUT_FUNC | MUX_CTL_IN_GPIO));
mx31_gpio_mux(IOMUX_MODE(0x92, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(0x93, MUX_CTL_GPIO));
/* FPGA reset Pin */
/* rstn = 0 */
gpio_direction_output(QONG_FPGA_RST_PIN, 0);
/* set interrupt pin as input */
gpio_direction_input(QONG_FPGA_IRQ_PIN);
/* FPGA JTAG Interface */
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SFS6, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_SCK6, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_CAPTURE, MUX_CTL_GPIO));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_COMPARE, MUX_CTL_GPIO));
gpio_direction_output(QONG_FPGA_TCK_PIN, 0);
gpio_direction_output(QONG_FPGA_TMS_PIN, 0);
gpio_direction_output(QONG_FPGA_TDI_PIN, 0);
gpio_direction_input(QONG_FPGA_TDO_PIN);
#endif
/* setup pins for UART1 */
mx31_gpio_mux(MUX_RXD1__UART1_RXD_MUX);
mx31_gpio_mux(MUX_TXD1__UART1_TXD_MUX);
mx31_gpio_mux(MUX_RTS1__UART1_RTS_B);
mx31_gpio_mux(MUX_CTS1__UART1_CTS_B);
/* setup pins for SPI (pmic) */
mx31_gpio_mux(MUX_CSPI2_SS0__CSPI2_SS0_B);
mx31_gpio_mux(MUX_CSPI2_MOSI__CSPI2_MOSI);
mx31_gpio_mux(MUX_CSPI2_MISO__CSPI2_MISO);
mx31_gpio_mux(MUX_CSPI2_SCLK__CSPI2_CLK);
mx31_gpio_mux(MUX_CSPI2_SPI_RDY__CSPI2_DATAREADY_B);
/* Setup pins for USB2 Host */
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_CLK, MUX_CTL_FUNC));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_DIR, MUX_CTL_FUNC));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_NXT, MUX_CTL_FUNC));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_STP, MUX_CTL_FUNC));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_DATA0, MUX_CTL_FUNC));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_USBH2_DATA1, MUX_CTL_FUNC));
#define H2_PAD_CFG (PAD_CTL_DRV_MAX | PAD_CTL_SRE_FAST | PAD_CTL_HYS_CMOS | \
PAD_CTL_ODE_CMOS | PAD_CTL_100K_PU)
mx31_set_pad(MX31_PIN_USBH2_CLK, H2_PAD_CFG);
mx31_set_pad(MX31_PIN_USBH2_DIR, H2_PAD_CFG);
mx31_set_pad(MX31_PIN_USBH2_NXT, H2_PAD_CFG);
mx31_set_pad(MX31_PIN_USBH2_STP, H2_PAD_CFG);
mx31_set_pad(MX31_PIN_USBH2_DATA0, H2_PAD_CFG); /* USBH2_DATA0 */
mx31_set_pad(MX31_PIN_USBH2_DATA1, H2_PAD_CFG); /* USBH2_DATA1 */
mx31_set_pad(MX31_PIN_SRXD6, H2_PAD_CFG); /* USBH2_DATA2 */
mx31_set_pad(MX31_PIN_STXD6, H2_PAD_CFG); /* USBH2_DATA3 */
mx31_set_pad(MX31_PIN_SFS3, H2_PAD_CFG); /* USBH2_DATA4 */
mx31_set_pad(MX31_PIN_SCK3, H2_PAD_CFG); /* USBH2_DATA5 */
mx31_set_pad(MX31_PIN_SRXD3, H2_PAD_CFG); /* USBH2_DATA6 */
mx31_set_pad(MX31_PIN_STXD3, H2_PAD_CFG); /* USBH2_DATA7 */
mx31_set_gpr(MUX_PGP_UH2, 1);
return 0;
}
int board_init(void)
{
/* Chip selects */
/* CS0: Nor Flash #0 - it must be init'ed when executing from DDR */
/* Assumptions: HCLK = 133 MHz, tACC = 130ns */
static const struct mxc_weimcs cs0 = {
/* sp wp bcd bcs psz pme sync dol cnc wsc ew wws edc */
CSCR_U(0, 0, 0, 0, 0, 0, 0, 0, 3, 21, 0, 0, 6),
/* oea oen ebwa ebwn csa ebc dsz csn psr cre wrap csen */
CSCR_L(0, 1, 3, 3, 1, 1, 5, 1, 0, 0, 0, 1),
/* ebra ebrn rwa rwn mum lah lbn lba dww dct wwu age cnc2 fce*/
CSCR_A(0, 1, 2, 2, 0, 0, 2, 0, 0, 0, 0, 0, 0, 0)
};
mxc_setup_weimcs(0, &cs0);
/* board id for linux */
gd->bd->bi_arch_number = MACH_TYPE_QONG;
gd->bd->bi_boot_params = (0x80000100); /* adress of boot parameters */
qong_fpga_init();
return 0;
}
int board_late_init(void)
{
u32 val;
struct pmic *p;
int ret;
ret = pmic_init(I2C_PMIC);
if (ret)
return ret;
p = pmic_get("FSL_PMIC");
if (!p)
return -ENODEV;
/* Enable RTC battery */
pmic_reg_read(p, REG_POWER_CTL0, &val);
pmic_reg_write(p, REG_POWER_CTL0, val | COINCHEN);
pmic_reg_write(p, REG_INT_STATUS1, RTCRSTI);
#ifdef CONFIG_HW_WATCHDOG
hw_watchdog_init();
#endif
return 0;
}
int checkboard(void)
{
printf("Board: DAVE/DENX Qong\n");
return 0;
}
int misc_init_r(void)
{
#ifdef CONFIG_QONG_FPGA
u32 tmp;
tmp = *(volatile u32*)QONG_FPGA_CTRL_VERSION;
printf("FPGA: ");
printf("version register = %u.%u.%u\n",
(tmp & 0xF000) >> 12, (tmp & 0x0F00) >> 8, tmp & 0x00FF);
#endif
return 0;
}
int board_eth_init(bd_t *bis)
{
#if defined(CONFIG_QONG_FPGA) && defined(CONFIG_DNET)
return dnet_eth_initialize(0, (void *)CONFIG_DNET_BASE, -1);
#else
return 0;
#endif
}
#if defined(CONFIG_QONG_FPGA) && defined(CONFIG_NAND_PLAT)
static void board_nand_setup(void)
{
/* CS3: NAND 8-bit */
static const struct mxc_weimcs cs3 = {
/* sp wp bcd bcs psz pme sync dol cnc wsc ew wws edc */
CSCR_U(0, 0, 0, 0, 0, 0, 0, 0, 1, 15, 0, 0, 0),
/* oea oen ebwa ebwn csa ebc dsz csn psr cre wrap csen */
CSCR_L(2, 0, 0, 1, 3, 1, 3, 3, 0, 0, 0, 1),
/* ebra ebrn rwa rwn mum lah lbn lba dww dct wwu age cnc2 fce*/
CSCR_A(0, 0, 0, 2, 0, 0, 2, 0, 0, 0, 0, 0, 0, 0)
};
mxc_setup_weimcs(3, &cs3);
mx31_set_gpr(MUX_SDCTL_CSD1_SEL, 1);
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_NFC_WP, MUX_CTL_IN_GPIO));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_NFC_CE, MUX_CTL_IN_GPIO));
mx31_gpio_mux(IOMUX_MODE(MUX_CTL_NFC_RB, MUX_CTL_IN_GPIO));
/* Make sure to reset the fpga else you cannot access NAND */
qong_fpga_reset();
/* Enable NAND flash */
gpio_set_value(15, 1);
gpio_set_value(14, 1);
gpio_direction_output(15, 0);
gpio_direction_input(16);
gpio_direction_input(14);
}
int qong_nand_rdy(void *chip)
{
udelay(1);
return gpio_get_value(16);
}
void qong_nand_select_chip(struct mtd_info *mtd, int chip)
{
if (chip >= 0)
gpio_set_value(15, 0);
else
gpio_set_value(15, 1);
}
void qong_nand_plat_init(void *chip)
{
struct nand_chip *nand = (struct nand_chip *)chip;
nand->chip_delay = 20;
nand->select_chip = qong_nand_select_chip;
nand->options &= ~NAND_BUSWIDTH_16;
board_nand_setup();
}
#endif