| /* | |
| * (C) Copyright 2001-2004 | |
| * Matthias Fuchs, esd gmbh germany, matthias.fuchs@esd-electronics.com | |
| * Stefan Roese, esd gmbh germany, stefan.roese@esd-electronics.com | |
| * | |
| * SPDX-License-Identifier: GPL-2.0+ | |
| */ | |
| #include <common.h> | |
| #include <asm/processor.h> | |
| #include <asm/io.h> | |
| #include <command.h> | |
| /* ------------------------------------------------------------------------- */ | |
| #ifdef FPGA_DEBUG | |
| #define DBG(x...) printf(x) | |
| #else | |
| #define DBG(x...) | |
| #endif /* DEBUG */ | |
| #define MAX_ONES 226 | |
| #ifdef CONFIG_SYS_FPGA_PRG | |
| # define FPGA_PRG CONFIG_SYS_FPGA_PRG /* FPGA program pin (ppc output) */ | |
| # define FPGA_CLK CONFIG_SYS_FPGA_CLK /* FPGA clk pin (ppc output) */ | |
| # define FPGA_DATA CONFIG_SYS_FPGA_DATA /* FPGA data pin (ppc output) */ | |
| # define FPGA_DONE CONFIG_SYS_FPGA_DONE /* FPGA done pin (ppc input) */ | |
| # define FPGA_INIT CONFIG_SYS_FPGA_INIT /* FPGA init pin (ppc input) */ | |
| #else | |
| # define FPGA_PRG 0x04000000 /* FPGA program pin (ppc output) */ | |
| # define FPGA_CLK 0x02000000 /* FPGA clk pin (ppc output) */ | |
| # define FPGA_DATA 0x01000000 /* FPGA data pin (ppc output) */ | |
| # define FPGA_DONE 0x00800000 /* FPGA done pin (ppc input) */ | |
| # define FPGA_INIT 0x00400000 /* FPGA init pin (ppc input) */ | |
| #endif | |
| #define ERROR_FPGA_PRG_INIT_LOW -1 /* Timeout after PRG* asserted */ | |
| #define ERROR_FPGA_PRG_INIT_HIGH -2 /* Timeout after PRG* deasserted */ | |
| #define ERROR_FPGA_PRG_DONE -3 /* Timeout after programming */ | |
| #ifndef SET_FPGA | |
| # define SET_FPGA(data) out_be32((void *)GPIO0_OR, data) | |
| #endif | |
| #ifdef FPGA_PROG_ACTIVE_HIGH | |
| # define FPGA_PRG_LOW FPGA_PRG | |
| # define FPGA_PRG_HIGH 0 | |
| #else | |
| # define FPGA_PRG_LOW 0 | |
| # define FPGA_PRG_HIGH FPGA_PRG | |
| #endif | |
| #define FPGA_CLK_LOW 0 | |
| #define FPGA_CLK_HIGH FPGA_CLK | |
| #define FPGA_DATA_LOW 0 | |
| #define FPGA_DATA_HIGH FPGA_DATA | |
| #define FPGA_WRITE_1 { \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_LOW | FPGA_DATA_HIGH); /* set clock to 0 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_LOW | FPGA_DATA_HIGH); /* set data to 1 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_HIGH); /* set clock to 1 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_HIGH);} /* set data to 1 */ | |
| #define FPGA_WRITE_0 { \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_LOW | FPGA_DATA_HIGH); /* set clock to 0 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_LOW | FPGA_DATA_LOW); /* set data to 0 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_LOW); /* set clock to 1 */ \ | |
| SET_FPGA(FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_HIGH);} /* set data to 1 */ | |
| #ifndef FPGA_DONE_STATE | |
| # define FPGA_DONE_STATE (in_be32((void *)GPIO0_IR) & FPGA_DONE) | |
| #endif | |
| #ifndef FPGA_INIT_STATE | |
| # define FPGA_INIT_STATE (in_be32((void *)GPIO0_IR) & FPGA_INIT) | |
| #endif | |
| static int fpga_boot (const unsigned char *fpgadata, int size) | |
| { | |
| int i, index, len; | |
| int count; | |
| unsigned char b; | |
| #ifdef CONFIG_SYS_FPGA_SPARTAN2 | |
| int j; | |
| #else | |
| int bit; | |
| #endif | |
| /* display infos on fpgaimage */ | |
| index = 15; | |
| for (i = 0; i < 4; i++) { | |
| len = fpgadata[index]; | |
| DBG ("FPGA: %s\n", &(fpgadata[index + 1])); | |
| index += len + 3; | |
| } | |
| #ifdef CONFIG_SYS_FPGA_SPARTAN2 | |
| /* search for preamble 0xFFFFFFFF */ | |
| while (1) { | |
| if ((fpgadata[index] == 0xff) && (fpgadata[index + 1] == 0xff) | |
| && (fpgadata[index + 2] == 0xff) | |
| && (fpgadata[index + 3] == 0xff)) | |
| break; /* preamble found */ | |
| else | |
| index++; | |
| } | |
| #else | |
| /* search for preamble 0xFF2X */ | |
| for (index = 0; index < size - 1; index++) { | |
| if ((fpgadata[index] == 0xff) | |
| && ((fpgadata[index + 1] & 0xf0) == 0x30)) | |
| break; | |
| } | |
| index += 2; | |
| #endif | |
| DBG ("FPGA: configdata starts at position 0x%x\n", index); | |
| DBG ("FPGA: length of fpga-data %d\n", size - index); | |
| /* | |
| * Setup port pins for fpga programming | |
| */ | |
| #ifndef CONFIG_M5249 | |
| out_be32 ((void *)GPIO0_ODR, 0x00000000); /* no open drain pins */ | |
| /* setup for output */ | |
| out_be32 ((void *)GPIO0_TCR, | |
| in_be32 ((void *)GPIO0_TCR) | | |
| FPGA_PRG | FPGA_CLK | FPGA_DATA); | |
| #endif | |
| SET_FPGA (FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_HIGH); /* set pins to high */ | |
| DBG ("%s, ", (FPGA_DONE_STATE == 0) ? "NOT DONE" : "DONE"); | |
| DBG ("%s\n", (FPGA_INIT_STATE == 0) ? "NOT INIT" : "INIT"); | |
| /* | |
| * Init fpga by asserting and deasserting PROGRAM* | |
| */ | |
| SET_FPGA (FPGA_PRG_LOW | FPGA_CLK_HIGH | FPGA_DATA_HIGH); /* set prog active */ | |
| /* Wait for FPGA init line low */ | |
| count = 0; | |
| while (FPGA_INIT_STATE) { | |
| udelay (1000); /* wait 1ms */ | |
| /* Check for timeout - 100us max, so use 3ms */ | |
| if (count++ > 3) { | |
| DBG ("FPGA: Booting failed!\n"); | |
| return ERROR_FPGA_PRG_INIT_LOW; | |
| } | |
| } | |
| DBG ("%s, ", (FPGA_DONE_STATE == 0) ? "NOT DONE" : "DONE"); | |
| DBG ("%s\n", (FPGA_INIT_STATE == 0) ? "NOT INIT" : "INIT"); | |
| /* deassert PROGRAM* */ | |
| SET_FPGA (FPGA_PRG_HIGH | FPGA_CLK_HIGH | FPGA_DATA_HIGH); /* set prog inactive */ | |
| /* Wait for FPGA end of init period . */ | |
| count = 0; | |
| while (!(FPGA_INIT_STATE)) { | |
| udelay (1000); /* wait 1ms */ | |
| /* Check for timeout */ | |
| if (count++ > 3) { | |
| DBG ("FPGA: Booting failed!\n"); | |
| return ERROR_FPGA_PRG_INIT_HIGH; | |
| } | |
| } | |
| DBG ("%s, ", (FPGA_DONE_STATE == 0) ? "NOT DONE" : "DONE"); | |
| DBG ("%s\n", (FPGA_INIT_STATE == 0) ? "NOT INIT" : "INIT"); | |
| DBG ("write configuration data into fpga\n"); | |
| /* write configuration-data into fpga... */ | |
| #ifdef CONFIG_SYS_FPGA_SPARTAN2 | |
| /* | |
| * Load uncompressed image into fpga | |
| */ | |
| for (i = index; i < size; i++) { | |
| b = fpgadata[i]; | |
| for (j = 0; j < 8; j++) { | |
| if ((b & 0x80) == 0x80) { | |
| FPGA_WRITE_1; | |
| } else { | |
| FPGA_WRITE_0; | |
| } | |
| b <<= 1; | |
| } | |
| } | |
| #else | |
| /* send 0xff 0x20 */ | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_1; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_0; | |
| FPGA_WRITE_0; | |
| /* | |
| ** Bit_DeCompression | |
| ** Code 1 .. maxOnes : n '1's followed by '0' | |
| ** maxOnes + 1 .. maxOnes + 1 : n - 1 '1's no '0' | |
| ** maxOnes + 2 .. 254 : n - (maxOnes + 2) '0's followed by '1' | |
| ** 255 : '1' | |
| */ | |
| for (i = index; i < size; i++) { | |
| b = fpgadata[i]; | |
| if ((b >= 1) && (b <= MAX_ONES)) { | |
| for (bit = 0; bit < b; bit++) { | |
| FPGA_WRITE_1; | |
| } | |
| FPGA_WRITE_0; | |
| } else if (b == (MAX_ONES + 1)) { | |
| for (bit = 1; bit < b; bit++) { | |
| FPGA_WRITE_1; | |
| } | |
| } else if ((b >= (MAX_ONES + 2)) && (b <= 254)) { | |
| for (bit = 0; bit < (b - (MAX_ONES + 2)); bit++) { | |
| FPGA_WRITE_0; | |
| } | |
| FPGA_WRITE_1; | |
| } else if (b == 255) { | |
| FPGA_WRITE_1; | |
| } | |
| } | |
| #endif | |
| DBG ("%s, ", (FPGA_DONE_STATE == 0) ? "NOT DONE" : "DONE"); | |
| DBG ("%s\n", (FPGA_INIT_STATE == 0) ? "NOT INIT" : "INIT"); | |
| /* | |
| * Check if fpga's DONE signal - correctly booted ? | |
| */ | |
| /* Wait for FPGA end of programming period . */ | |
| count = 0; | |
| while (!(FPGA_DONE_STATE)) { | |
| udelay (1000); /* wait 1ms */ | |
| /* Check for timeout */ | |
| if (count++ > 3) { | |
| DBG ("FPGA: Booting failed!\n"); | |
| return ERROR_FPGA_PRG_DONE; | |
| } | |
| } | |
| DBG ("FPGA: Booting successful!\n"); | |
| return 0; | |
| } |