#ifndef TFA98XX_INTERNALS_H
#define TFA98XX_INTERNALS_H

#include "tfa_service.h"

/*
 * the order matches the ACK bits order in TFA98XX_CF_STATUS
 */
enum tfa_fw_event { /* not all available on each device */
	tfa_fw_i2c_cmd_ack,
	tfa_fw_reset_start,
	tfa_fw_short_on_mips,
	tfa_fw_soft_mute_ready,
	tfa_fw_volume_ready,
	tfa_fw_error_damage,
	tfa_fw_calibrate_done,
	tfa_fw_max
};

/* the following type mappings are compiler specific */
#define subaddress_t unsigned char

/* module Ids */
#define MODULE_FRAMEWORK        0
#define MODULE_SPEAKERBOOST     1
#define MODULE_BIQUADFILTERBANK 2
#define MODULE_SETRE 			9

/* RPC commands */
/* SET */
#define FW_PAR_ID_SET_MEMORY            0x03
#define FW_PAR_ID_SET_SENSES_DELAY      0x04
#define FW_PAR_ID_SETSENSESCAL          0x05
#define FW_PAR_ID_SET_INPUT_SELECTOR    0x06
#define FW_PAR_ID_SET_OUTPUT_SELECTOR   0x08
#define FW_PAR_ID_SET_PROGRAM_CONFIG    0x09
#define FW_PAR_ID_SET_GAINS             0x0A
#define FW_PAR_ID_SET_MEMTRACK          0x0B
#define TFA1_FW_PAR_ID_SET_CURRENT_DELAY 0x03
#define TFA1_FW_PAR_ID_SET_CURFRAC_DELAY 0x06
/* GET */
#define FW_PAR_ID_GET_MEMORY            0x83
#define FW_PAR_ID_GLOBAL_GET_INFO       0x84
#define FW_PAR_ID_GET_FEATURE_INFO      0x85
#define FW_PAR_ID_GET_MEMTRACK          0x8B
#define FW_PAR_ID_GET_TAG               0xFF

/* Load a full model into SpeakerBoost. */
/* SET */
#define SB_PARAM_SET_ALGO_PARAMS        0x00
#define SB_PARAM_SET_LAGW               0x01
#define SB_PARAM_SET_ALGO_PARAMS_WITHOUT_RESET	0x02
#define SB_PARAM_SET_LSMODEL            0x06
#define SB_PARAM_SET_MBDRC              0x07
#define SB_PARAM_SET_MBDRC_WITHOUT_RESET	0x08
#define SB_PARAM_SET_DRC                0x0F
/* GET */
#define SB_PARAM_GET_ALGO_PARAMS        0x80
#define SB_PARAM_GET_LAGW               0x81
#define SB_PARAM_GET_RE0                0x85
#define SB_PARAM_GET_LSMODEL            0x86
#define SB_PARAM_GET_MBDRC	        	0x87
#define SB_PARAM_GET_MBDRC_DYNAMICS		0x89
#define SB_PARAM_GET_TAG                0xFF

#define SB_PARAM_SET_EQ		        0x0A	/* 2 Equaliser Filters. */
#define SB_PARAM_SET_PRESET             0x0D	/* Load a preset */
#define SB_PARAM_SET_CONFIG	        0x0E	/* Load a config */
#define SB_PARAM_SET_AGCINS             0x10
#define SB_PARAM_SET_CURRENT_DELAY      0x03
#define SB_PARAM_GET_STATE              0xC0
#define SB_PARAM_GET_XMODEL             0xC1	/* Gets current Excursion Model. */

/* sets the speaker calibration impedance (@25 degrees celsius) */
#define SB_PARAM_SET_RE0                0x89

#define BFB_PAR_ID_SET_COEFS            0x00
#define BFB_PAR_ID_GET_COEFS            0x80
#define BFB_PAR_ID_GET_CONFIG           0x81

/* for compatibility */
#define FW_PARAM_GET_STATE        	FW_PAR_ID_GLOBAL_GET_INFO
#define FW_PARAM_GET_FEATURE_BITS 	FW_PAR_ID_GET_FEATURE_BITS


/* RPC Status results */
#define STATUS_OK                  0
#define STATUS_INVALID_MODULE_ID   2
#define STATUS_INVALID_PARAM_ID    3
#define STATUS_INVALID_INFO_ID     4

/* the maximum message length in the communication with the DSP */
#define TFA2_MAX_PARAM_SIZE (507*3) /* TFA2 */
#define TFA1_MAX_PARAM_SIZE (145*3) /* TFA1 */

#define ROUND_DOWN(a,n) (((a)/(n))*(n))

/* feature bits */
#define FEATURE1_TCOEF 0x100 /* bit8 set means tCoefA expected */
#define FEATURE1_DRC   0x200 /* bit9 NOT set means DRC expected */

/* DSP firmware xmem defines */
#define TFA1_FW_XMEM_CALIBRATION_DONE	231
#define TFA2_FW_XMEM_CALIBRATION_DONE   516
#define TFA1_FW_XMEM_COUNT_BOOT		  	0xa1
#define TFA2_FW_XMEM_COUNT_BOOT		  	512
#define TFA2_FW_XMEM_CMD_COUNT			520

/* note that the following defs rely on the handle variable */
#define TFA_FW_XMEM_CALIBRATION_DONE 	TFA_FAM_FW(handle,XMEM_CALIBRATION_DONE)
#define TFA_FW_XMEM_COUNT_BOOT 			TFA_FAM_FW(handle,XMEM_COUNT_BOOT)
#define TFA_FW_XMEM_CMD_COUNT 			TFA_FAM_FW(handle,XMEM_CMD_COUNT)

#define TFA2_FW_ReZ_SCALE             	65536
#define TFA1_FW_ReZ_SCALE             	16384
#define TFA_FW_ReZ_SCALE              	TFA_FAM_FW(handle,ReZ_SCALE)


#endif /* TFA98XX_INTERNALS_H */