| Intel Bay Trail FSP UPD Binding |
| =============================== |
| |
| The device tree node which describes the overriding of the Intel Bay Trail FSP |
| UPD data for configuring the SoC. |
| |
| All properties can be found within the `upd-region` struct in |
| arch/x86/include/asm/arch-baytrail/fsp/fsp_vpd.h, under the same names, and in |
| Intel's FSP Binary Configuration Tool for Bay Trail. This list of properties is |
| matched up to Intel's E3800 FSPv4 release. |
| |
| # Boolean properties: |
| |
| - fsp,enable-sdio |
| - fsp,enable-sdcard |
| - fsp,enable-hsuart0 |
| - fsp,enable-hsuart1 |
| - fsp,enable-spi |
| - fsp,enable-sata |
| - fsp,enable-azalia |
| - fsp,enable-xhci |
| - fsp,enable-lpe |
| - fsp,lpss-sio-enable-pci-mode |
| - fsp,enable-dma0 |
| - fsp,enable-dma1 |
| - fsp,enable-i2-c0 |
| - fsp,enable-i2-c1 |
| - fsp,enable-i2-c2 |
| - fsp,enable-i2-c3 |
| - fsp,enable-i2-c4 |
| - fsp,enable-i2-c5 |
| - fsp,enable-i2-c6 |
| - fsp,enable-pwm0 |
| - fsp,enable-pwm1 |
| - fsp,enable-hsi |
| - fsp,mrc-debug-msg |
| - fsp,isp-enable |
| - fsp,scc-enable-pci-mode |
| - fsp,igd-render-standby |
| - fsp,txe-uma-enable |
| - fsp,emmc45-ddr50-enabled |
| - fsp,emmc45-hs200-enabled |
| - fsp,enable-igd |
| - fsp,enable-memory-down |
| |
| If you set "fsp,enable-memory-down" you are strongly encouraged to provide an |
| "fsp,memory-down-params{};" to specify how your memory is configured. If you do |
| not set "fsp,enable-memory-down", then the DIMM SPD information will be |
| discovered by the FSP and used to setup main memory. |
| |
| |
| # Integer properties: |
| |
| - fsp,mrc-init-tseg-size |
| - fsp,mrc-init-mmio-size |
| - fsp,mrc-init-spd-addr1 |
| - fsp,mrc-init-spd-addr2 |
| - fsp,emmc-boot-mode |
| - fsp,sata-mode |
| - fsp,igd-dvmt50-pre-alloc |
| - fsp,aperture-size |
| - fsp,gtt-size |
| - fsp,serial-debug-port-address |
| - fsp,serial-debug-port-type |
| - fsp,os-selection |
| - fsp,emmc45-retune-timer-value |
| |
| - fsp,memory-down-params { |
| |
| # Boolean properties: |
| |
| - fsp,dimm-0-enable |
| - fsp,dimm-1-enable |
| |
| # Integer properties: |
| |
| - fsp,dram-speed |
| - fsp,dram-type |
| - fsp,dimm-width |
| - fsp,dimm-density |
| - fsp,dimm-bus-width |
| - fsp,dimm-sides |
| - fsp,dimm-tcl |
| - fsp,dimm-trpt-rcd |
| - fsp,dimm-twr |
| - fsp,dimm-twtr |
| - fsp,dimm-trrd |
| - fsp,dimm-trtp |
| - fsp,dimm-tfaw |
| }; |
| |
| |
| Example (from MinnowMax Dual Core): |
| ----------------------------------- |
| |
| / { |
| ... |
| |
| fsp { |
| compatible = "intel,baytrail-fsp"; |
| fsp,mrc-init-tseg-size = <0>; |
| fsp,mrc-init-mmio-size = <0x800>; |
| fsp,mrc-init-spd-addr1 = <0xa0>; |
| fsp,mrc-init-spd-addr2 = <0xa2>; |
| fsp,emmc-boot-mode = <2>; |
| fsp,enable-sdio; |
| fsp,enable-sdcard; |
| fsp,enable-hsuart1; |
| fsp,enable-spi; |
| fsp,enable-sata; |
| fsp,sata-mode = <1>; |
| fsp,enable-xhci; |
| fsp,enable-lpe; |
| fsp,lpss-sio-enable-pci-mode; |
| fsp,enable-dma0; |
| fsp,enable-dma1; |
| fsp,enable-i2c0; |
| fsp,enable-i2c1; |
| fsp,enable-i2c2; |
| fsp,enable-i2c3; |
| fsp,enable-i2c4; |
| fsp,enable-i2c5; |
| fsp,enable-i2c6; |
| fsp,enable-pwm0; |
| fsp,enable-pwm1; |
| fsp,igd-dvmt50-pre-alloc = <2>; |
| fsp,aperture-size = <2>; |
| fsp,gtt-size = <2>; |
| fsp,serial-debug-port-address = <0x3f8>; |
| fsp,serial-debug-port-type = <1>; |
| fsp,mrc-debug-msg; |
| fsp,scc-enable-pci-mode; |
| fsp,os-selection = <4>; |
| fsp,emmc45-ddr50-enabled; |
| fsp,emmc45-retune-timer-value = <8>; |
| fsp,enable-igd; |
| fsp,enable-memory-down; |
| fsp,memory-down-params { |
| compatible = "intel,baytrail-fsp-mdp"; |
| fsp,dram-speed = <1>; |
| fsp,dram-type = <1>; |
| fsp,dimm-0-enable; |
| fsp,dimm-width = <1>; |
| fsp,dimm-density = <2>; |
| fsp,dimm-bus-width = <3>; |
| fsp,dimm-sides = <0>; |
| fsp,dimm-tcl = <0xb>; |
| fsp,dimm-trpt-rcd = <0xb>; |
| fsp,dimm-twr = <0xc>; |
| fsp,dimm-twtr = <6>; |
| fsp,dimm-trrd = <6>; |
| fsp,dimm-trtp = <6>; |
| fsp,dimm-tfaw = <0x14>; |
| }; |
| }; |
| |
| ... |
| }; |
