include/configs/qca953x.h

#define CONFIG_MIPS32 1   /* MIPS32 CPU core  */
#define CONFIG_BOOTDELAY 2   /* autoboot after 4 seconds */
#define CONFIG_TIMESTAMP        /* Print image info with timestamp */

/*
 * Console I/O configuration
 */
#define CONFIG_BAUDRATE 115200
#define CONFIG_SYS_BAUDRATE_TABLE  {115200}

/* Console I/O Buffer Size */
#define CONFIG_SYS_CBSIZE               512
/* Print Buffer Size */
#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16)

#define CONFIG_SYS_HUSH_PARSER
#define CONFIG_SYS_PROMPT_HUSH_PS2      "hush>"

/*
 * FLASH and environment organization
 */
#ifndef FLASH_SIZE
#define FLASH_SIZE 16
#endif

/*-----------------------------------------------------------------------
 * FLASH and environment organization
 */
#define CONFIG_SYS_MAX_FLASH_BANKS 1       /* max number of memory banks */
#define CFG_MAX_FLASH_BANKS     1       /* max number of memory banks */
#if (FLASH_SIZE == 32)
#define CFG_MAX_FLASH_SECT      512     /* max number of sectors on one chip */
#define ATH_MTDPARTS_MIB0       "64k(mib0)"
#define ATH_ROOTFS_SIZE         "14528k(rootfs)"
#elif (FLASH_SIZE == 16)
#define CFG_MAX_FLASH_SECT      256     /* max number of sectors on one chip */
#define ATH_MTDPARTS_MIB0       "64k(mib0)"
#define ATH_ROOTFS_SIZE         "14528k(rootfs)"
#elif (FLASH_SIZE == 8)
#define CFG_MAX_FLASH_SECT      128     /* max number of sectors on one chip */
#define ATH_MTDPARTS_MIB0       "64k(mib0)"
#define ATH_ROOTFS_SIZE         "6336k(rootfs)"
#elif (FLASH_SIZE == 1/2)
#define CFG_MAX_FLASH_SECT      8       /* max number of sectors on one chip */
#else
#define CFG_MAX_FLASH_SECT      64      /* max number of sectors on one chip */
#define ATH_MTDPARTS_MIB0       "64k(mib0)"
#define ATH_ROOTFS_SIZE         "6336k(rootfs)"
#endif

#define CFG_FLASH_SECTOR_SIZE   (64*1024)
#if (FLASH_SIZE == 32)
#define CFG_FLASH_SIZE          0x02000000      /* Total flash size */
#elif (FLASH_SIZE == 16)
#define CFG_FLASH_SIZE          0x01000000      /* Total flash size */
#elif (FLASH_SIZE == 8)
#define CFG_FLASH_SIZE          0x00800000      /* max number of sectors on one chip */
#elif (FLASH_SIZE == 1/2)
#define CFG_FLASH_SIZE          0x00080000      /* Total flash size */
#else
#define CFG_FLASH_SIZE          0x00400000      /* Total flash size */
#endif

#ifndef COMPRESSED_UBOOT
#define ENABLE_DYNAMIC_CONF     1
#endif

#undef CFG_ATHRS26_PHY

#if (CFG_MAX_FLASH_SECT * CFG_FLASH_SECTOR_SIZE) != CFG_FLASH_SIZE
#       error "Invalid flash configuration"
#endif

#define CFG_FLASH_WORD_SIZE     unsigned short

#if defined(CONFIG_ATH_NAND_BR) && defined(COMPRESSED_UBOOT)
#define CFG_FLASH_BASE                  0xa0100000
#else
/* NOR Flash start address */
#define CFG_FLASH_BASE                  0x9f000000
#endif

#ifdef COMPRESSED_UBOOT
#define BOOTSTRAP_TEXT_BASE             CFG_FLASH_BASE
#define BOOTSTRAP_CFG_MONITOR_BASE      BOOTSTRAP_TEXT_BASE
#endif

#define CONFIG_PCI_CONFIG_DATA_IN_OTP

/*
 * Defines to change flash size on reboot
 */
#ifdef ENABLE_DYNAMIC_CONF
#define CFG_DDR_MAGIC           0xaabacada
#define CFG_DDR_MAGIC_F         (UBOOT_ENV_SEC_START + CFG_FLASH_SECTOR_SIZE - 0x30)
#define CFG_DDR_CONFIG_VAL_F    *(volatile int *)(CFG_DDR_MAGIC_F + 4)
#define CFG_DDR_CONFIG2_VAL_F   *(volatile int *)(CFG_DDR_MAGIC_F + 8)
#define CFG_DDR_EXT_MODE_VAL_F  *(volatile int *)(CFG_DDR_MAGIC_F + 12)
#endif

/*
** Parameters defining the location of the calibration/initialization
** information for the two Merlin devices.
** NOTE: **This will change with different flash configurations**
*/

#define BOARDCAL                        (CFG_FLASH_BASE + CFG_FLASH_SIZE - 0x10000)
#define WLANCAL                         (BOARDCAL + 0x1000)
#define ATHEROS_PRODUCT_ID              137
#define CAL_SECTOR                      (CFG_MAX_FLASH_SECT - 1)

/* For Merlin, both PCI, PCI-E interfaces are valid */
#define ATH_ART_PCICFG_OFFSET           12

/*
 * The following for ENV settings
 */

#define CONFIG_SYS_MAXARGS 16
#define CONFIG_SYS_FLASH_BASE           0x9f000000
#define CONFIG_SYS_MAX_FLASH_SECT       256

#define CONFIG_ENV_IS_IN_FLASH  1
#define CONFIG_ENV_SIZE CFG_FLASH_SECTOR_SIZE //CFG_ENV_SIZE
#define CONFIG_ENV_ADDR 0x9f040000

/* Timer Specific */
#define CONFIG_SYS_MHZ  550
/* Since the count is incremented every other tick, divide by 2 -- CFG_HZ*/
#define CONFIG_SYS_MIPS_TIMER_FREQ      ((CONFIG_SYS_MHZ * 1000000)/2)


#define CFG_DDR_REFRESH_VAL             0x4138

/*
 * The following #defines are needed to get flash environment right
 */
#define CONFIG_SYS_MONITOR_BASE 0x9f000000
#define CONFIG_SYS_MONITOR_LEN  (192 << 10)
#define CONFIG_SYS_MALLOC_LEN (128*1024)
#define CONFIG_SYS_BOOTPARAMS_LEN (64*1024)

/*
 * Cache Configuration
 */
#define CONFIG_SYS_CACHELINE_SIZE 32
#define CONFIG_SYS_ICACHE_SIZE 65536
#define CONFIG_SYS_DCACHE_SIZE 32768

#define CONFIG_PCI 1
#define CONFIG_CMD_PCI
#define CONFIG_PCI_SCAN_SHOW

/*#define CONFIG_USB 1*/

#if pll
#define CFG_PLL_FREQ (pll)
#else
#define CFG_PLL_FREQ	CFG_PLL_650_600_200
#endif

#define CONFIG_ATH_SOC 1
#define CONFIG_ATHEROS          1
#define CONFIG_MACH_QCA953x     1
#define CFG_INIT_STACK_IN_SRAM  1
#define __CONFIG_BOARD_NAME ap147
#define CONFIG_BOARD_NAME "ap147"
#define BUILD_VERSION "g36c341f-dirty-1"
#define CFG_ATHRS27_PHY 1
#define CFG_ATH_GMAC_NMACS 2
#define BOARD_NAME "AP147"

#define CONFIG_LAST_STAGE_INIT
#define CONFIG_DISPLAY_BOARDINFO 1
#define CONFIG_CUSTOM_BOARDINFO 1

#define CONFIG_SYS_TEXT_BASE 0x9f000000

#define CONFIG_SYS_SDRAM_BASE 0x80000000
#define CONFIG_SYS_LOAD_ADDR 0x81000000

/*
 * Cache lock for stack
 */
#define CONFIG_SYS_INIT_SP_OFFSET 0x1000
#define CFG_INIT_SRAM_SP_OFFSET 0xbd001800

/*
 * Image type
 */
#define CONFIG_LZMA 1
#define CONFIG_IMAGE_FORMAT_LEGACY

/*
 * ethernet environment
 */
#define CONFIG_SYS_RX_ETH_BUFFER 8
#define CONFIG_TFTP_BLOCKSIZE 512
#define CONFIG_MII 1
#define CFG_CMD_MII 1
#define CONFIG_COMMANDS 1