blob: 50ccd551a693e555eca78d9bf3f99adcd5206ab3 [file] [log] [blame]
//------------------------------------------------------------------------------
// <copyright file="wmix.h" company="Atheros">
// Copyright (c) 2004-2010 Atheros Corporation. All rights reserved.
//
// The software source and binaries included in this development package are
// licensed, not sold. You, or your company, received the package under one
// or more license agreements. The rights granted to you are specifically
// listed in these license agreement(s). All other rights remain with Atheros
// Communications, Inc., its subsidiaries, or the respective owner including
// those listed on the included copyright notices. Distribution of any
// portion of this package must be in strict compliance with the license
// agreement(s) terms.
// </copyright>
//
// <summary>
// Wifi driver for AR6003
// </summary>
//
//------------------------------------------------------------------------------
//==============================================================================
// Author(s): ="Atheros"
//==============================================================================
/*
* This file contains extensions of the WMI protocol specified in the
* Wireless Module Interface (WMI). It includes definitions of all
* extended commands and events. Extensions include useful commands
* that are not directly related to wireless activities. They may
* be hardware-specific, and they might not be supported on all
* implementations.
*
* Extended WMIX commands are encapsulated in a WMI message with
* cmd=WMI_EXTENSION_CMD.
*/
#ifndef _WMIX_H_
#define _WMIX_H_
#ifdef __cplusplus
extern "C" {
#endif
#ifndef ATH_TARGET
#include "athstartpack.h"
#endif
#include "dbglog.h"
/*
* Extended WMI commands are those that are needed during wireless
* operation, but which are not really wireless commands. This allows,
* for instance, platform-specific commands. Extended WMI commands are
* embedded in a WMI command message with WMI_COMMAND_ID=WMI_EXTENSION_CMDID.
* Extended WMI events are similarly embedded in a WMI event message with
* WMI_EVENT_ID=WMI_EXTENSION_EVENTID.
*/
typedef PREPACK struct {
A_UINT32 commandId;
} POSTPACK WMIX_CMD_HDR;
typedef enum {
WMIX_DSETOPEN_REPLY_CMDID = 0x2001,
WMIX_DSETDATA_REPLY_CMDID,
WMIX_GPIO_OUTPUT_SET_CMDID,
WMIX_GPIO_INPUT_GET_CMDID,
WMIX_GPIO_REGISTER_SET_CMDID,
WMIX_GPIO_REGISTER_GET_CMDID,
WMIX_GPIO_INTR_ACK_CMDID,
WMIX_HB_CHALLENGE_RESP_CMDID,
WMIX_DBGLOG_CFG_MODULE_CMDID,
WMIX_PROF_CFG_CMDID, /* 0x200a */
WMIX_PROF_ADDR_SET_CMDID,
WMIX_PROF_START_CMDID,
WMIX_PROF_STOP_CMDID,
WMIX_PROF_COUNT_GET_CMDID,
} WMIX_COMMAND_ID;
typedef enum {
WMIX_DSETOPENREQ_EVENTID = 0x3001,
WMIX_DSETCLOSE_EVENTID,
WMIX_DSETDATAREQ_EVENTID,
WMIX_GPIO_INTR_EVENTID,
WMIX_GPIO_DATA_EVENTID,
WMIX_GPIO_ACK_EVENTID,
WMIX_HB_CHALLENGE_RESP_EVENTID,
WMIX_DBGLOG_EVENTID,
WMIX_PROF_COUNT_EVENTID,
} WMIX_EVENT_ID;
/*
* =============DataSet support=================
*/
/*
* WMIX_DSETOPENREQ_EVENTID
* DataSet Open Request Event
*/
typedef PREPACK struct {
A_UINT32 dset_id;
A_UINT32 targ_dset_handle; /* echo'ed, not used by Host, */
A_UINT32 targ_reply_fn; /* echo'ed, not used by Host, */
A_UINT32 targ_reply_arg; /* echo'ed, not used by Host, */
} POSTPACK WMIX_DSETOPENREQ_EVENT;
/*
* WMIX_DSETCLOSE_EVENTID
* DataSet Close Event
*/
typedef PREPACK struct {
A_UINT32 access_cookie;
} POSTPACK WMIX_DSETCLOSE_EVENT;
/*
* WMIX_DSETDATAREQ_EVENTID
* DataSet Data Request Event
*/
typedef PREPACK struct {
A_UINT32 access_cookie;
A_UINT32 offset;
A_UINT32 length;
A_UINT32 targ_buf; /* echo'ed, not used by Host, */
A_UINT32 targ_reply_fn; /* echo'ed, not used by Host, */
A_UINT32 targ_reply_arg; /* echo'ed, not used by Host, */
} POSTPACK WMIX_DSETDATAREQ_EVENT;
typedef PREPACK struct {
A_UINT32 status;
A_UINT32 targ_dset_handle;
A_UINT32 targ_reply_fn;
A_UINT32 targ_reply_arg;
A_UINT32 access_cookie;
A_UINT32 size;
A_UINT32 version;
} POSTPACK WMIX_DSETOPEN_REPLY_CMD;
typedef PREPACK struct {
A_UINT32 status;
A_UINT32 targ_buf;
A_UINT32 targ_reply_fn;
A_UINT32 targ_reply_arg;
A_UINT32 length;
A_UINT8 buf[1];
} POSTPACK WMIX_DSETDATA_REPLY_CMD;
/*
* =============GPIO support=================
* NB: Some of the WMIX APIs use a 32-bit mask. On Targets that support
* more than 32 GPIO pins, those APIs only support the first 32 GPIO pins.
*/
#include "gpio.h"
/*
* Set GPIO pin output state.
* In order for output to be driven, a pin must be enabled for output.
* This can be done during initialization through the GPIO Configuration
* DataSet, or during operation with the enable_mask.
*
* If a request is made to simultaneously set/clear or set/disable or
* clear/disable or disable/enable, results are undefined.
*/
typedef PREPACK struct {
A_UINT32 set_mask; /* pins to set */
A_UINT32 clear_mask; /* pins to clear */
A_UINT32 enable_mask; /* pins to enable for output */
A_UINT32 disable_mask; /* pins to disable/tristate */
} POSTPACK WMIX_GPIO_OUTPUT_SET_CMD;
/*
* Set a GPIO register. For debug/exceptional cases.
* Values for gpioreg_id are GPIO_ID_*, defined in a
* platform-dependent header, gpio.h.
*/
typedef PREPACK struct {
A_UINT32 gpioreg_id; /* GPIO register ID */
A_UINT32 value; /* value to write */
} POSTPACK WMIX_GPIO_REGISTER_SET_CMD;
/* Get a GPIO register. For debug/exceptional cases. */
typedef PREPACK struct {
A_UINT32 gpioreg_id; /* GPIO register to read */
} POSTPACK WMIX_GPIO_REGISTER_GET_CMD;
/*
* Host acknowledges and re-arms GPIO interrupts. A single
* message should be used to acknowledge all interrupts that
* were delivered in an earlier WMIX_GPIO_INTR_EVENT message.
*/
typedef PREPACK struct {
A_UINT32 ack_mask; /* interrupts to acknowledge */
} POSTPACK WMIX_GPIO_INTR_ACK_CMD;
/*
* Target informs Host of GPIO interrupts that have ocurred since the
* last WMIX_GIPO_INTR_ACK_CMD was received. Additional information --
* the current GPIO input values is provided -- in order to support
* use of a GPIO interrupt as a Data Valid signal for other GPIO pins.
*/
typedef PREPACK struct {
A_UINT32 intr_mask; /* pending GPIO interrupts */
A_UINT32 input_values; /* recent GPIO input values */
} POSTPACK WMIX_GPIO_INTR_EVENT;
/*
* Target responds to Host's earlier WMIX_GPIO_INPUT_GET_CMDID request
* using a GPIO_DATA_EVENT with
* value set to the mask of GPIO pin inputs and
* reg_id set to GPIO_ID_NONE
*
*
* Target responds to Hosts's earlier WMIX_GPIO_REGISTER_GET_CMDID request
* using a GPIO_DATA_EVENT with
* value set to the value of the requested register and
* reg_id identifying the register (reflects the original request)
* NB: reg_id supports the future possibility of unsolicited
* WMIX_GPIO_DATA_EVENTs (for polling GPIO input), and it may
* simplify Host GPIO support.
*/
typedef PREPACK struct {
A_UINT32 value;
A_UINT32 reg_id;
} POSTPACK WMIX_GPIO_DATA_EVENT;
/*
* =============Error Detection support=================
*/
/*
* WMIX_HB_CHALLENGE_RESP_CMDID
* Heartbeat Challenge Response command
*/
typedef PREPACK struct {
A_UINT32 cookie;
A_UINT32 source;
} POSTPACK WMIX_HB_CHALLENGE_RESP_CMD;
/*
* WMIX_HB_CHALLENGE_RESP_EVENTID
* Heartbeat Challenge Response Event
*/
#define WMIX_HB_CHALLENGE_RESP_EVENT WMIX_HB_CHALLENGE_RESP_CMD
typedef PREPACK struct {
struct dbglog_config_s config;
} POSTPACK WMIX_DBGLOG_CFG_MODULE_CMD;
/*
* =============Target Profiling support=================
*/
typedef PREPACK struct {
A_UINT32 period; /* Time (in 30.5us ticks) between samples */
A_UINT32 nbins;
} POSTPACK WMIX_PROF_CFG_CMD;
typedef PREPACK struct {
A_UINT32 addr;
} POSTPACK WMIX_PROF_ADDR_SET_CMD;
/*
* Target responds to Hosts's earlier WMIX_PROF_COUNT_GET_CMDID request
* using a WMIX_PROF_COUNT_EVENT with
* addr set to the next address
* count set to the corresponding count
*/
typedef PREPACK struct {
A_UINT32 addr;
A_UINT32 count;
} POSTPACK WMIX_PROF_COUNT_EVENT;
#ifndef ATH_TARGET
#include "athendpack.h"
#endif
#ifdef __cplusplus
}
#endif
#endif /* _WMIX_H_ */