/* ---------------------------------------------------------------------------- | |
* SAM Software Package License | |
* ---------------------------------------------------------------------------- | |
* Copyright (c) 2015, Atmel Corporation | |
* | |
* All rights reserved. | |
* | |
* Redistribution and use in source and binary forms, with or without | |
* modification, are permitted provided that the following conditions are met: | |
* | |
* - Redistributions of source code must retain the above copyright notice, | |
* this list of conditions and the disclaimer below. | |
* | |
* Atmel's name may not be used to endorse or promote products derived from | |
* this software without specific prior written permission. | |
* | |
* DISCLAIMER: THIS SOFTWARE IS PROVIDED BY ATMEL "AS IS" AND ANY EXPRESS OR | |
* IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF | |
* MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT ARE | |
* DISCLAIMED. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, | |
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT | |
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, | |
* OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF | |
* LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING | |
* NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, | |
* EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. | |
* ---------------------------------------------------------------------------- | |
*/ | |
/** | |
* \file | |
* | |
* \par Purpose | |
* | |
* This module provides several definitions and methods for using an USART | |
* peripheral. | |
* | |
* \par Usage | |
* | |
* -# Enable the USART peripheral clock in the PMC. | |
* -# Enable the required USART PIOs (see pio.h). | |
* -# Configure the UART by calling usart_configure. | |
* -# Enable the transmitter and/or the receiver of the USART using | |
* usart_set_transmitter_enabled and usart_set_receiver_enabled. | |
* -# Send data through the USART using the usart_write methods. | |
* -# Receive data from the USART using the usart_read functions; the availability of data can be polled | |
* with usart_is_data_available. | |
* -# Disable the transmitter and/or the receiver of the USART with | |
* usart_set_transmitter_enabled and usart_set_receiver_enabled. | |
*/ | |
#ifndef _FLEXCOM_ | |
#define _FLEXCOM_ | |
/*------------------------------------------------------------------------------ | |
* Headers | |
*------------------------------------------------------------------------------*/ | |
#include "chip.h" | |
#include <stdint.h> | |
#ifdef __cplusplus | |
extern "C" { | |
#endif | |
/*------------------------------------------------------------------------------*/ | |
/* Exported functions */ | |
/*------------------------------------------------------------------------------*/ | |
extern void flexcom_select(Flexcom * flexcom, uint32_t protocol); | |
#ifdef __cplusplus | |
} | |
#endif | |
#endif /* #ifndef _FLEXCOM_ */ |