| Linux on the CRIS architecture | |
| ============================== | |
| This is a port of Linux to Axis Communications ETRAX 100LX, | |
| ETRAX FS and ARTPEC-3 embedded network CPUs. | |
| For more information about CRIS and ETRAX please see further below. | |
| In order to compile this you need a version of gcc with support for the | |
| ETRAX chip family. Please see this link for more information on how to | |
| download the compiler and other tools useful when building and booting | |
| software for the ETRAX platform: | |
| http://developer.axis.com/wiki/doku.php?id=axis:install-howto-2_20 | |
| What is CRIS ? | |
| -------------- | |
| CRIS is an acronym for 'Code Reduced Instruction Set'. It is the CPU | |
| architecture in Axis Communication AB's range of embedded network CPU's, | |
| called ETRAX. | |
| The ETRAX 100LX chip | |
| -------------------- | |
| For reference, please see the following link: | |
| http://www.axis.com/products/dev_etrax_100lx/index.htm | |
| The ETRAX 100LX is a 100 MIPS processor with 8kB cache, MMU, and a very broad | |
| range of built-in interfaces, all with modern scatter/gather DMA. | |
| Memory interfaces: | |
| * SRAM | |
| * NOR-flash/ROM | |
| * EDO or page-mode DRAM | |
| * SDRAM | |
| I/O interfaces: | |
| * one 10/100 Mbit/s ethernet controller | |
| * four serial-ports (up to 6 Mbit/s) | |
| * two synchronous serial-ports for multimedia codec's etc. | |
| * USB host controller and USB slave | |
| * ATA | |
| * SCSI | |
| * two parallel-ports | |
| * two generic 8-bit ports | |
| (not all interfaces are available at the same time due to chip pin | |
| multiplexing) | |
| ETRAX 100LX is CRISv10 architecture. | |
| The ETRAX FS and ARTPEC-3 chips | |
| ------------------------------- | |
| The ETRAX FS is a 200MHz 32-bit RISC processor with on-chip 16kB | |
| I-cache and 16kB D-cache and with a wide range of device interfaces | |
| including multiple high speed serial ports and an integrated USB 1.1 PHY. | |
| The ARTPEC-3 is a variant of the ETRAX FS with additional IO-units | |
| used by the Axis Communications network cameras. | |
| See below link for more information: | |
| http://www.axis.com/products/dev_etrax_fs/index.htm | |
| ETRAX FS and ARTPEC-3 are both CRISv32 architectures. | |
| Bootlog | |
| ------- | |
| Just as an example, this is the debug-output from a boot of Linux 2.4 on | |
| a board with ETRAX 100LX. The displayed BogoMIPS value is 5 times too small :) | |
| At the end you see some user-mode programs booting like telnet and ftp daemons. | |
| Linux version 2.4.1 (bjornw@godzilla.axis.se) (gcc version 2.96 20000427 (experimental)) #207 Wed Feb 21 15:48:15 CET 2001 | |
| ROM fs in RAM, size 1376256 bytes | |
| Setting up paging and the MMU. | |
| On node 0 totalpages: 2048 | |
| zone(0): 2048 pages. | |
| zone(1): 0 pages. | |
| zone(2): 0 pages. | |
| Linux/CRIS port on ETRAX 100LX (c) 2001 Axis Communications AB | |
| Kernel command line: | |
| Calibrating delay loop... 19.91 BogoMIPS | |
| Memory: 13872k/16384k available (587k kernel code, 2512k reserved, 44k data, 24k init) | |
| kmem_create: Forcing size word alignment - vm_area_struct | |
| kmem_create: Forcing size word alignment - filp | |
| Dentry-cache hash table entries: 2048 (order: 1, 16384 bytes) | |
| Buffer-cache hash table entries: 2048 (order: 0, 8192 bytes) | |
| Page-cache hash table entries: 2048 (order: 0, 8192 bytes) | |
| kmem_create: Forcing size word alignment - kiobuf | |
| kmem_create: Forcing size word alignment - bdev_cache | |
| Inode-cache hash table entries: 1024 (order: 0, 8192 bytes) | |
| kmem_create: Forcing size word alignment - inode_cache | |
| POSIX conformance testing by UNIFIX | |
| Linux NET4.0 for Linux 2.4 | |
| Based upon Swansea University Computer Society NET3.039 | |
| Starting kswapd v1.8 | |
| kmem_create: Forcing size word alignment - file lock cache | |
| kmem_create: Forcing size word alignment - blkdev_requests | |
| block: queued sectors max/low 9109kB/3036kB, 64 slots per queue | |
| ETRAX 100LX 10/100MBit ethernet v2.0 (c) 2000 Axis Communications AB | |
| eth0 initialized | |
| eth0: changed MAC to 00:40:8C:CD:00:00 | |
| ETRAX 100LX serial-driver $Revision: 1.7 $, (c) 2000 Axis Communications AB | |
| ttyS0 at 0xb0000060 is a builtin UART with DMA | |
| ttyS1 at 0xb0000068 is a builtin UART with DMA | |
| ttyS2 at 0xb0000070 is a builtin UART with DMA | |
| ttyS3 at 0xb0000078 is a builtin UART with DMA | |
| Axis flash mapping: 200000 at 50000000 | |
| Axis flash: Found 1 x16 CFI device at 0x0 in 16 bit mode | |
| Amd/Fujitsu Extended Query Table v1.0 at 0x0040 | |
| Axis flash: JEDEC Device ID is 0xC4. Assuming broken CFI table. | |
| Axis flash: Swapping erase regions for broken CFI table. | |
| number of CFI chips: 1 | |
| Using default partition table | |
| I2C driver v2.2, (c) 1999-2001 Axis Communications AB | |
| ETRAX 100LX GPIO driver v2.1, (c) 2001 Axis Communications AB | |
| NET4: Linux TCP/IP 1.0 for NET4.0 | |
| IP Protocols: ICMP, UDP, TCP | |
| kmem_create: Forcing size word alignment - ip_dst_cache | |
| IP: routing cache hash table of 1024 buckets, 8Kbytes | |
| TCP: Hash tables configured (established 2048 bind 2048) | |
| NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. | |
| VFS: Mounted root (cramfs filesystem) readonly. | |
| Init starts up... | |
| Mounted none on /proc ok. | |
| Setting up eth0 with ip 10.13.9.116 and mac 00:40:8c:18:04:60 | |
| eth0: changed MAC to 00:40:8C:18:04:60 | |
| Setting up lo with ip 127.0.0.1 | |
| Default gateway is 10.13.9.1 | |
| Hostname is bbox1 | |
| Telnetd starting, using port 23. | |
| using /bin/sash as shell. | |
| sftpd[15]: sftpd $Revision: 1.7 $ starting up | |
| And here is how some /proc entries look: | |
| 17# cd /proc | |
| 17# cat cpuinfo | |
| cpu : CRIS | |
| cpu revision : 10 | |
| cpu model : ETRAX 100LX | |
| cache size : 8 kB | |
| fpu : no | |
| mmu : yes | |
| ethernet : 10/100 Mbps | |
| token ring : no | |
| scsi : yes | |
| ata : yes | |
| usb : yes | |
| bogomips : 99.84 | |
| 17# cat meminfo | |
| total: used: free: shared: buffers: cached: | |
| Mem: 7028736 925696 6103040 114688 0 229376 | |
| Swap: 0 0 0 | |
| MemTotal: 6864 kB | |
| MemFree: 5960 kB | |
| MemShared: 112 kB | |
| Buffers: 0 kB | |
| Cached: 224 kB | |
| Active: 224 kB | |
| Inact_dirty: 0 kB | |
| Inact_clean: 0 kB | |
| Inact_target: 0 kB | |
| HighTotal: 0 kB | |
| HighFree: 0 kB | |
| LowTotal: 6864 kB | |
| LowFree: 5960 kB | |
| SwapTotal: 0 kB | |
| SwapFree: 0 kB | |
| 17# ls -l /bin | |
| -rwxr-xr-x 1 342 100 10356 Jan 01 00:00 ifconfig | |
| -rwxr-xr-x 1 342 100 17548 Jan 01 00:00 init | |
| -rwxr-xr-x 1 342 100 9488 Jan 01 00:00 route | |
| -rwxr-xr-x 1 342 100 46036 Jan 01 00:00 sftpd | |
| -rwxr-xr-x 1 342 100 48104 Jan 01 00:00 sh | |
| -rwxr-xr-x 1 342 100 16252 Jan 01 00:00 telnetd | |