| # |
| # for USB OTG silicon based on Mentor Graphics INVENTRA designs |
| # |
| |
| ccflags-$(CONFIG_USB_MUSB_DEBUG) := -DDEBUG |
| |
| obj-$(CONFIG_USB_MUSB_HDRC) += musb_hdrc.o |
| |
| musb_hdrc-y := musb_core.o |
| |
| musb_hdrc-$(CONFIG_USB_GADGET_MUSB_HDRC) += musb_gadget_ep0.o musb_gadget.o |
| musb_hdrc-$(CONFIG_USB_MUSB_HDRC_HCD) += musb_virthub.o musb_host.o |
| musb_hdrc-$(CONFIG_DEBUG_FS) += musb_debugfs.o |
| ifeq ($(CONFIG_USB_MUSB_DEBUG),y) |
| musb_hdrc-$(CONFIG_PROC_FS) += musb_procfs.o |
| endif |
| # Hardware Glue Layer |
| obj-$(CONFIG_USB_MUSB_OMAP2PLUS_GLUE) += omap2430.o |
| obj-$(CONFIG_USB_MUSB_AM35X_GLUE) += am35x.o |
| obj-$(CONFIG_USB_MUSB_TI81XX_GLUE) += ti81xx.o |
| obj-$(CONFIG_USB_MUSB_TUSB6010_GLUE) += tusb6010.o |
| obj-$(CONFIG_USB_MUSB_DAVINCI_GLUE) += davinci.o |
| obj-$(CONFIG_USB_MUSB_DA8XX_GLUE) += da8xx.o |
| obj-$(CONFIG_USB_MUSB_BLACKFIN_GLUE) += blackfin.o |
| obj-$(CONFIG_USB_MUSB_UX500_GLUE) += ux500.o |
| |
| # the kconfig must guarantee that only one of the |
| # possible I/O schemes will be enabled at a time ... |
| # PIO only, or DMA (several potential schemes). |
| # though PIO is always there to back up DMA, and for ep0 |
| |
| obj-$(CONFIG_USB_INVENTRA_DMA_HW) += musbhsdma.o |
| obj-$(CONFIG_USB_TI_CPPI_DMA_HW) += cppi_dma.o |
| obj-$(CONFIG_USB_TI_CPPI41_DMA_HW) += cppi41dma.o |
| cppi41dma-y += cppi41.o cppi41_dma.o |
| obj-$(CONFIG_USB_TUSB_OMAP_DMA_HW) += tusb6010_omap.o |
| |
