| U-Boot for UniPhier SoC family | |
| ============================== | |
| Tested toolchains | |
| ----------------- | |
| (a) Ubuntu packages (CROSS_COMPILE=arm-linux-gnueabi-) | |
| If you are building U-Boot on Ubuntu, its standard package is recommended. | |
| You can install it as follows: | |
| $ sudo apt-get install gcc-arm-linux-gnueabi- | |
| (b) Linaro compilers (CROSS_COMPILE=arm-linux-gnueabihf-) | |
| You can download pre-built toolchains from: | |
| http://www.linaro.org/downloads/ | |
| (c) kernel.org compilers (CROSS_COMPILE=arm-unknown-linux-gnueabi-) | |
| You can download pre-built toolchains from: | |
| ftp://www.kernel.org/pub/tools/crosstool/files/bin/ | |
| Compile the source | |
| ------------------ | |
| PH1-Pro4: | |
| $ make ph1_pro4_defconfig | |
| $ make CROSS_COMPILE=arm-linux-gnueabi- | |
| PH1-LD4: | |
| $ make ph1_ld4_defconfig | |
| $ make CROSS_COMPILE=arm-linux-gnueabi- | |
| PH1-sLD8: | |
| $ make ph1_sld8_defconfig | |
| $ make CROSS_COMPILE=arm-linux-gnueabi- | |
| You may wish to change the "CROSS_COMPILE=arm-linux-gnueabi-" | |
| to use your favorite compiler. | |
| Burn U-Boot images to NAND | |
| -------------------------- | |
| Write two files to the NAND device as follows: | |
| - spl/u-boot-spl.bin at the offset address 0x00000000 | |
| - u-boot-dtb.img at the offset address 0x00010000 | |
| If a TFTP server is available, the images can be easily updated. | |
| Just copy the u-boot-spl.bin and u-boot-dtb.img to the TFTP public directory, | |
| and then run the following command at the U-Boot command line: | |
| => run nandupdate | |
| UniPhier specific commands | |
| -------------------------- | |
| - pinmon (enabled by CONFIG_CMD_PINMON) | |
| shows the boot mode pins that has been latched at the power-on reset | |
| - ddrphy (enabled by CONFIG_CMD_DDRPHY_DUMP) | |
| shows the DDR PHY parameters set by the PHY training | |
| Supported devices | |
| ----------------- | |
| - UART (on-chip) | |
| - NAND | |
| - USB 2.0 (EHCI) | |
| - USB 3.0 (xHCI) | |
| - LAN (on-board SMSC9118) | |
| - I2C | |
| - EEPROM (connected to the on-board I2C bus) | |
| - Support card (SRAM, NOR flash, some peripherals) | |
| -- | |
| Masahiro Yamada <yamada.m@jp.panasonic.com> | |
| Feb. 2015 |