blob: 62e7200654188fecbe718b181b25d7ad28885561 [file] [log] [blame]
* Freescale Smart Direct Memory Access (SDMA) Controller for i.MX
Required properties:
- compatible : Should be "fsl,<chip>-sdma"
- reg : Should contain SDMA registers location and length
- interrupts : Should contain SDMA interrupt
- #dma-cells : Must be <3>.
The first cell specifies the DMA request/event ID. See details below
about the second and third cell.
- gpr : The phandle to general purpose register node.
- fsl,sdma-event-remap : Register bits of sdma event remap, the format is
<reg shift val>.
reg is the gpr register offset.
shift is the bit offset of event remap.
val is the value of the bit to be set.
- fsl,sdma-ram-script-name : Should contain the full path of SDMA RAM
scripts firmware
The second cell of dma phandle specifies the peripheral type of DMA transfer.
The full ID of peripheral types can be found below.
ID transfer type
---------------------
0 MCU domain SSI
1 Shared SSI
2 MMC
3 SDHC
4 MCU domain UART
5 Shared UART
6 FIRI
7 MCU domain CSPI
8 Shared CSPI
9 SIM
10 ATA
11 CCM
12 External peripheral
13 Memory Stick Host Controller
14 Shared Memory Stick Host Controller
15 DSP
16 Memory
17 FIFO type Memory
18 SPDIF
19 IPU Memory
20 ASRC
21 ESAI
22 HDMI Audio
23 SAI
The third cell specifies the transfer priority as below.
ID transfer priority
-------------------------
0 High
1 Medium
2 Low
Examples:
sdma@83fb0000 {
compatible = "fsl,imx51-sdma", "fsl,imx35-sdma";
reg = <0x83fb0000 0x4000>;
interrupts = <6>;
#dma-cells = <3>;
fsl,sdma-ram-script-name = "sdma-imx51.bin";
};
DMA clients connected to the i.MX SDMA controller must use the format
described in the dma.txt file.
Examples:
ssi2: ssi@70014000 {
compatible = "fsl,imx51-ssi", "fsl,imx21-ssi";
reg = <0x70014000 0x4000>;
interrupts = <30>;
clocks = <&clks 49>;
dmas = <&sdma 24 1 0>,
<&sdma 25 1 0>;
dma-names = "rx", "tx";
fsl,fifo-depth = <15>;
};