blob: b381fa696bf95c7e35c5a850f2a9425d9f9e7fab [file] [log] [blame]
Required properties:
- compatible: should be "ti,usbhs-host"
- reg: should contain one register range i.e. start and length
- ti,hwmods: must contain "usb_host_hs"
Optional properties:
- num-ports: number of USB ports. Usually this is automatically detected
from the IP's revision register but can be overridden by specifying
this property. A maximum of 3 ports are supported at the moment.
- portN-mode: String specifying the port mode for port N, where N can be
from 1 to 3. If the port mode is not specified, that port is treated
as unused. When specified, it must be one of the following.
- single-ulpi-bypass: Must be present if the controller contains a single
ULPI bypass control bit. e.g. OMAP3 silicon <= ES2.1
Required properties if child node exists:
- #address-cells: Must be 1
- #size-cells: Must be 1
- ranges: must be present
Properties for children:
The OMAP HS USB Host subsystem contains EHCI and OHCI controllers.
See Documentation/devicetree/bindings/usb/omap-ehci.txt and
Example for OMAP4:
usbhshost: usbhshost@4a064000 {
compatible = "ti,usbhs-host";
reg = <0x4a064000 0x800>;
ti,hwmods = "usb_host_hs";
#address-cells = <1>;
#size-cells = <1>;
usbhsohci: ohci@4a064800 {
compatible = "ti,ohci-omap3", "usb-ohci";
reg = <0x4a064800 0x400>;
interrupt-parent = <&gic>;
interrupts = <0 76 0x4>;
usbhsehci: ehci@4a064c00 {
compatible = "ti,ehci-omap", "usb-ehci";
reg = <0x4a064c00 0x400>;
interrupt-parent = <&gic>;
interrupts = <0 77 0x4>;
&usbhshost {
port1-mode = "ehci-phy";
port2-mode = "ehci-tll";
port3-mode = "ehci-phy";
&usbhsehci {
phys = <&hsusb1_phy 0 &hsusb3_phy>;