| ADS Bitsy Single Board Computer | |
| (It is different from Bitsy(iPAQ) of Compaq) | |
| For more details, contact Applied Data Systems or see | |
| http://www.applieddata.net/products.html | |
| The Linux support for this product has been provided by | |
| Woojung Huh <whuh@applieddata.net> | |
| Use 'make adsbitsy_config' before any 'make config'. | |
| This will set up defaults for ADS Bitsy support. | |
| The kernel zImage is linked to be loaded and executed at 0xc0400000. | |
| Linux can be used with the ADS BootLoader that ships with the | |
| newer rev boards. See their documentation on how to load Linux. | |
| Supported peripherals: | |
| - SA1100 LCD frame buffer (8/16bpp...sort of) | |
| - SA1111 USB Master | |
| - SA1100 serial port | |
| - pcmcia, compact flash | |
| - touchscreen(ucb1200) | |
| - console on LCD screen | |
| - serial ports (ttyS[0-2]) | |
| - ttyS0 is default for serial console | |
| To do: | |
| - everything else! :-) | |
| Notes: | |
| - The flash on board is divided into 3 partitions. | |
| You should be careful to use flash on board. | |
| Its partition is different from GraphicsClient Plus and GraphicsMaster | |
| - 16bpp mode requires a different cable than what ships with the board. | |
| Contact ADS or look through the manual to wire your own. Currently, | |
| if you compile with 16bit mode support and switch into a lower bpp | |
| mode, the timing is off so the image is corrupted. This will be | |
| fixed soon. | |
| Any contribution can be sent to nico@fluxnic.net and will be greatly welcome! |