blob: 4c7669ad681b8e0a1f8f97014e04affc5db39754 [file] [log] [blame]
Binding for TO CDCE925 programmable I2C clock synthesizers.
This binding uses the common clock binding[1].
[1] Documentation/devicetree/bindings/clock/clock-bindings.txt
The driver provides clock sources for each output Y1 through Y5.
Required properties:
- compatible: Shall be "ti,cdce925"
- reg: I2C device address.
- clocks: Points to a fixed parent clock that provides the input frequency.
- #clock-cells: From common clock bindings: Shall be 1.
Optional properties:
- xtal-load-pf: Crystal load-capacitor value to fine-tune performance on a
board, or to compensate for external influences.
For both PLL1 and PLL2 an optional child node can be used to specify spread
spectrum clocking parameters for a board.
- spread-spectrum: SSC mode as defined in the data sheet.
- spread-spectrum-center: Use "centered" mode instead of "max" mode. When
present, the clock runs at the requested frequency on average. Otherwise
the requested frequency is the maximum value of the SCC range.
clockgen: cdce925pw@64 {
compatible = "cdce925";
reg = <0x64>;
clocks = <&xtal_27Mhz>;
#clock-cells = <1>;
xtal-load-pf = <5>;
/* PLL options to get SSC 1% centered */
PLL2 {
spread-spectrum = <4>;