blob: 89b3250f049b6ead36b110df609a1ab340ac0fb8 [file] [log] [blame]
* Samsung's I2C controller
The Samsung's I2C controller is used to interface with I2C devices.
Required properties:
- compatible: value should be either of the following.
(a) "samsung, s3c2410-i2c", for i2c compatible with s3c2410 i2c.
(b) "samsung, s3c2440-i2c", for i2c compatible with s3c2440 i2c.
(c) "samsung, s3c2440-hdmiphy-i2c", for s3c2440-like i2c used
inside HDMIPHY block found on several samsung SoCs
(d) "samsung, exynos5440-i2c", for s3c2440-like i2c used
on EXYNOS5440 which does not need GPIO configuration.
(e) "samsung, exynos5-sata-phy-i2c", for s3c2440-like i2c used as
a host to SATA PHY controller on an internal bus.
- reg: physical base address of the controller and length of memory mapped
- interrupts: interrupt number to the cpu.
- samsung,i2c-sda-delay: Delay (in ns) applied to data line (SDA) edges.
Required for all cases except "samsung,s3c2440-hdmiphy-i2c":
- Samsung GPIO variant (deprecated):
- gpios: The order of the gpios should be the following: <SDA, SCL>.
The gpio specifier depends on the gpio controller. Required in all
cases except for "samsung,s3c2440-hdmiphy-i2c" whose input/output
lines are permanently wired to the respective clienta
- Pinctrl variant (preferred, if available):
- pinctrl-0: Pin control group to be used for this controller.
- pinctrl-names: Should contain only one value - "default".
Optional properties:
- samsung,i2c-slave-addr: Slave address in multi-master environment. If not
specified, default value is 0.
- samsung,i2c-max-bus-freq: Desired frequency in Hz of the bus. If not
specified, the default value in Hz is 100000.
- samsung,sysreg-phandle - handle to syscon used to control the system registers
i2c@13870000 {
compatible = "samsung,s3c2440-i2c";
reg = <0x13870000 0x100>;
interrupts = <345>;
samsung,i2c-sda-delay = <100>;
samsung,i2c-max-bus-freq = <100000>;
/* Samsung GPIO variant begins here */
gpios = <&gpd1 2 0 /* SDA */
&gpd1 3 0 /* SCL */>;
/* Samsung GPIO variant ends here */
/* Pinctrl variant begins here */
pinctrl-0 = <&i2c3_bus>;
pinctrl-names = "default";
/* Pinctrl variant ends here */
#address-cells = <1>;
#size-cells = <0>;
wm8994@1a {
compatible = "wlf,wm8994";
reg = <0x1a>;