blob: 5c96d41899f19532eda9e9bff2be34ebce97ce4c [file] [log] [blame]
* Freescale MXS Application UART (AUART)
Required properties for all SoCs:
- compatible : Should be one of fallowing variants:
"fsl,imx23-auart" - Freescale i.MX23
"fsl,imx28-auart" - Freescale i.MX28
"alphascale,asm9260-auart" - Alphascale ASM9260
- reg : Address and length of the register set for the device
- interrupts : Should contain the auart interrupt numbers
- dmas: DMA specifier, consisting of a phandle to DMA controller node
and AUART DMA channel ID.
Refer to dma.txt and fsl-mxs-dma.txt for details.
- dma-names: "rx" for RX channel, "tx" for TX channel.
Required properties for "alphascale,asm9260-auart":
- clocks : the clocks feeding the watchdog timer. See clock-bindings.txt
- clock-names : should be set to
"mod" - source for tick counter.
"ahb" - ahb gate.
Optional properties:
- uart-has-rtscts : Indicate the UART has RTS and CTS lines
for hardware flow control,
it also means you enable the DMA support for this UART.
- {rts,cts,dtr,dsr,rng,dcd}-gpios: specify a GPIO for RTS/CTS/DTR/DSR/RI/DCD
line respectively. It will use specified PIO instead of the peripheral
function pin for the USART feature.
If unsure, don't specify this property.
auart0: serial@8006a000 {
compatible = "fsl,imx28-auart", "fsl,imx23-auart";
reg = <0x8006a000 0x2000>;
interrupts = <112>;
dmas = <&dma_apbx 8>, <&dma_apbx 9>;
dma-names = "rx", "tx";
cts-gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
dsr-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
dcd-gpios = <&gpio1 17 GPIO_ACTIVE_LOW>;
Note: Each auart port should have an alias correctly numbered in "aliases"
aliases {
serial0 = &auart0;
serial1 = &auart1;
serial2 = &auart2;
serial3 = &auart3;
serial4 = &auart4;