| # | |
| # Myricom device configuration | |
| # | |
| config NET_VENDOR_MYRI | |
| bool "Myricom devices" | |
| default y | |
| depends on PCI && INET | |
| ---help--- | |
| If you have a network (Ethernet) card belonging to this class, say | |
| Y and read the Ethernet-HOWTO, available from | |
| <http://www.tldp.org/docs.html#howto>. | |
| Note that the answer to this question doesn't directly affect the | |
| kernel: saying N will just cause the configurator to skip all | |
| the questions about Myricom cards. If you say Y, you will be asked for | |
| your specific card in the following questions. | |
| if NET_VENDOR_MYRI | |
| config MYRI10GE | |
| tristate "Myricom Myri-10G Ethernet support" | |
| depends on PCI && INET | |
| select FW_LOADER | |
| select CRC32 | |
| ---help--- | |
| This driver supports Myricom Myri-10G Dual Protocol interface in | |
| Ethernet mode. If the eeprom on your board is not recent enough, | |
| you will need a newer firmware image. | |
| You may get this image or more information, at: | |
| <http://www.myri.com/scs/download-Myri10GE.html> | |
| To compile this driver as a module, choose M here. The module | |
| will be called myri10ge. | |
| config MYRI10GE_DCA | |
| bool "Direct Cache Access (DCA) Support" | |
| default y | |
| depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m) | |
| ---help--- | |
| Say Y here if you want to use Direct Cache Access (DCA) in the | |
| driver. DCA is a method for warming the CPU cache before data | |
| is used, with the intent of lessening the impact of cache misses. | |
| endif # NET_VENDOR_MYRI |