blob: 866fcdd0f4ebd2abcea051aed3e758172604baf5 [file] [log] [blame]
Maxim MAX8952 voltage regulator
Required properties:
- compatible: must be equal to "maxim,max8952"
- reg: I2C slave address, usually 0x60
- max8952,dvs-mode-microvolt: array of 4 integer values defining DVS voltages
in microvolts. All values must be from range <770000, 1400000>
- any required generic properties defined in regulator.txt
Optional properties:
- max8952,vid-gpios: array of two GPIO pins used for DVS voltage selection
- max8952,en-gpio: GPIO used to control enable status of regulator
- max8952,default-mode: index of default DVS voltage, from <0, 3> range
- max8952,sync-freq: sync frequency, must be one of following values:
- 0: 26 MHz
- 1: 13 MHz
- 2: 19.2 MHz
Defaults to 26 MHz if not specified.
- max8952,ramp-speed: voltage ramp speed, must be one of following values:
- 0: 32mV/us
- 1: 16mV/us
- 2: 8mV/us
- 3: 4mV/us
- 4: 2mV/us
- 5: 1mV/us
- 6: 0.5mV/us
- 7: 0.25mV/us
Defaults to 32mV/us if not specified.
- any available generic properties defined in regulator.txt
Example:
vdd_arm_reg: pmic@60 {
compatible = "maxim,max8952";
reg = <0x60>;
/* max8952-specific properties */
max8952,vid-gpios = <&gpx0 3 0>, <&gpx0 4 0>;
max8952,en-gpio = <&gpx0 1 0>;
max8952,default-mode = <0>;
max8952,dvs-mode-microvolt = <1250000>, <1200000>,
<1050000>, <950000>;
max8952,sync-freq = <0>;
max8952,ramp-speed = <0>;
/* generic regulator properties */
regulator-name = "vdd_arm";
regulator-min-microvolt = <770000>;
regulator-max-microvolt = <1400000>;
regulator-always-on;
regulator-boot-on;
};