| # | |
| # 1-wire slaves configuration | |
| # | |
| menu "1-wire Slaves" | |
| config W1_SLAVE_THERM | |
| tristate "Thermal family implementation" | |
| help | |
| Say Y here if you want to connect 1-wire thermal sensors to your | |
| wire. | |
| config W1_SLAVE_SMEM | |
| tristate "Simple 64bit memory family implementation" | |
| help | |
| Say Y here if you want to connect 1-wire | |
| simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire. | |
| config W1_SLAVE_DS2431 | |
| tristate "1kb EEPROM family support (DS2431)" | |
| help | |
| Say Y here if you want to use a 1-wire | |
| 1kb EEPROM family device (DS2431) | |
| config W1_SLAVE_DS2433 | |
| tristate "4kb EEPROM family support (DS2433)" | |
| help | |
| Say Y here if you want to use a 1-wire | |
| 4kb EEPROM family device (DS2433). | |
| config W1_SLAVE_DS2433_CRC | |
| bool "Protect DS2433 data with a CRC16" | |
| depends on W1_SLAVE_DS2433 | |
| select CRC16 | |
| help | |
| Say Y here to protect DS2433 data with a CRC16. | |
| Each block has 30 bytes of data and a two byte CRC16. | |
| Full block writes are only allowed if the CRC is valid. | |
| config W1_SLAVE_DS2760 | |
| tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)" | |
| depends on W1 | |
| help | |
| If you enable this you will have the DS2760 battery monitor | |
| chip support. | |
| The battery monitor chip is used in many batteries/devices | |
| as the one who is responsible for charging/discharging/monitoring | |
| Li+ batteries. | |
| If you are unsure, say N. | |
| config W1_SLAVE_BQ27000 | |
| tristate "BQ27000 slave support" | |
| depends on W1 | |
| help | |
| Say Y here if you want to use a hdq | |
| bq27000 slave support. | |
| endmenu |