blob: f9d70252bbb298b9450dfdde78cb425808a0e85c [file] [log] [blame]
ST DWC3 glue logic
This file documents the parameters for the dwc3-st driver.
This driver controls the glue logic used to configure the dwc3 core on
STiH407 based platforms.
Required properties:
- compatible : must be "st,stih407-dwc3"
- reg : glue logic base address and USB syscfg ctrl register offset
- reg-names : should be "reg-glue" and "syscfg-reg"
- st,syscon : should be phandle to system configuration node which
encompasses the glue registers
- resets : list of phandle and reset specifier pairs. There should be two entries, one
for the powerdown and softreset lines of the usb3 IP
- reset-names : list of reset signal names. Names should be "powerdown" and "softreset"
See: Documentation/devicetree/bindings/reset/st,sti-powerdown.txt
See: Documentation/devicetree/bindings/reset/reset.txt
- #address-cells, #size-cells : should be '1' if the device has sub-nodes
with 'reg' property
- pinctl-names : A pinctrl state named "default" must be defined
See: Documentation/devicetree/bindings/pinctrl/pinctrl-binding.txt
- pinctrl-0 : Pin control group
See: Documentation/devicetree/bindings/pinctrl/pinctrl-binding.txt
- ranges : allows valid 1:1 translation between child's address space and
parent's address space
The dwc3 core should be added as subnode to ST DWC3 glue as shown in the
example below. The DT binding details of dwc3 can be found in:
NB: The dr_mode property described in [1] is NOT optional for this driver, as the default value
is "otg", which isn't supported by this SoC. Valid dr_mode values for dwc3-st are either "host"
or "device".
[1] Documentation/devicetree/bindings/usb/generic.txt
st_dwc3: dwc3@8f94000 {
status = "disabled";
compatible = "st,stih407-dwc3";
reg = <0x08f94000 0x1000>, <0x110 0x4>;
reg-names = "reg-glue", "syscfg-reg";
st,syscfg = <&syscfg_core>;
resets = <&powerdown STIH407_USB3_POWERDOWN>,
<&softreset STIH407_MIPHY2_SOFTRESET>;
reset-names = "powerdown",
#address-cells = <1>;
#size-cells = <1>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_usb3>;
dwc3: dwc3@9900000 {
compatible = "snps,dwc3";
reg = <0x09900000 0x100000>;
interrupts = <GIC_SPI 155 IRQ_TYPE_NONE>;
dr_mode = "host";
phys-names = "usb2-phy", "usb3-phy";
phys = <&usb2_picophy2>, <&phy_port2 MIPHY_TYPE_USB>;