blob: 1852906517ab1c1b691fb4df75f8b5bdd7c9c78c [file] [log] [blame]
Atmel maXTouch touchscreen/touchpad
Required properties:
- compatible:
- reg: The I2C address of the device
- interrupts: The sink for the touchpad's IRQ output
See ../interrupt-controller/interrupts.txt
Optional properties for main touchpad device:
- linux,gpio-keymap: When enabled, the SPT_GPIOPWN_T19 object sends messages
on GPIO bit changes. An array of up to 8 entries can be provided
indicating the Linux keycode mapped to each bit of the status byte,
starting at the LSB. Linux keycodes are defined in
Note: the numbering of the GPIOs and the bit they start at varies between
maXTouch devices. You must either refer to the documentation, or
experiment to determine which bit corresponds to which input. Use
KEY_RESERVED for unused padding values.
touch@4b {
compatible = "atmel,maxtouch";
reg = <0x4b>;
interrupt-parent = <&gpio>;
interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_LOW>;