| /* | |
| * TI DaVinci clock definitions | |
| * | |
| * Copyright (C) 2006-2007 Texas Instruments. | |
| * Copyright (C) 2008-2009 Deep Root Systems, LLC | |
| * | |
| * This program is free software; you can redistribute it and/or modify | |
| * it under the terms of the GNU General Public License version 2 as | |
| * published by the Free Software Foundation. | |
| */ | |
| #ifndef __ARCH_ARM_DAVINCI_CLOCK_H | |
| #define __ARCH_ARM_DAVINCI_CLOCK_H | |
| #define DAVINCI_PLL1_BASE 0x01c40800 | |
| #define DAVINCI_PLL2_BASE 0x01c40c00 | |
| #define MAX_PLL 2 | |
| /* PLL/Reset register offsets */ | |
| #define PLLCTL 0x100 | |
| #define PLLCTL_PLLEN BIT(0) | |
| #define PLLCTL_PLLPWRDN BIT(1) | |
| #define PLLCTL_PLLRST BIT(3) | |
| #define PLLCTL_PLLDIS BIT(4) | |
| #define PLLCTL_PLLENSRC BIT(5) | |
| #define PLLCTL_CLKMODE BIT(8) | |
| #define PLLM 0x110 | |
| #define PLLM_PLLM_MASK 0xff | |
| #define PREDIV 0x114 | |
| #define PLLDIV1 0x118 | |
| #define PLLDIV2 0x11c | |
| #define PLLDIV3 0x120 | |
| #define POSTDIV 0x128 | |
| #define BPDIV 0x12c | |
| #define PLLCMD 0x138 | |
| #define PLLSTAT 0x13c | |
| #define PLLALNCTL 0x140 | |
| #define PLLDCHANGE 0x144 | |
| #define PLLCKEN 0x148 | |
| #define PLLCKSTAT 0x14c | |
| #define PLLSYSTAT 0x150 | |
| #define PLLDIV4 0x160 | |
| #define PLLDIV5 0x164 | |
| #define PLLDIV6 0x168 | |
| #define PLLDIV7 0x16c | |
| #define PLLDIV8 0x170 | |
| #define PLLDIV9 0x174 | |
| #define PLLDIV_EN BIT(15) | |
| #define PLLDIV_RATIO_MASK 0x1f | |
| /* | |
| * OMAP-L138 system reference guide recommends a wait for 4 OSCIN/CLKIN | |
| * cycles to ensure that the PLLC has switched to bypass mode. Delay of 1us | |
| * ensures we are good for all > 4MHz OSCIN/CLKIN inputs. Typically the input | |
| * is ~25MHz. Units are micro seconds. | |
| */ | |
| #define PLL_BYPASS_TIME 1 | |
| /* From OMAP-L138 datasheet table 6-4. Units are micro seconds */ | |
| #define PLL_RESET_TIME 1 | |
| /* | |
| * From OMAP-L138 datasheet table 6-4; assuming prediv = 1, sqrt(pllm) = 4 | |
| * Units are micro seconds. | |
| */ | |
| #define PLL_LOCK_TIME 20 | |
| #ifndef __ASSEMBLER__ | |
| #include <linux/list.h> | |
| #include <asm/clkdev.h> | |
| #define PLLSTAT_GOSTAT BIT(0) | |
| #define PLLCMD_GOSET BIT(0) | |
| struct pll_data { | |
| u32 phys_base; | |
| void __iomem *base; | |
| u32 num; | |
| u32 flags; | |
| u32 input_rate; | |
| u32 div_ratio_mask; | |
| }; | |
| #define PLL_HAS_PREDIV 0x01 | |
| #define PLL_HAS_POSTDIV 0x02 | |
| struct clk { | |
| struct list_head node; | |
| struct module *owner; | |
| const char *name; | |
| unsigned long rate; | |
| unsigned long maxrate; /* H/W supported max rate */ | |
| u8 usecount; | |
| u8 lpsc; | |
| u8 gpsc; | |
| u32 flags; | |
| struct clk *parent; | |
| struct list_head children; /* list of children */ | |
| struct list_head childnode; /* parent's child list node */ | |
| struct pll_data *pll_data; | |
| u32 div_reg; | |
| unsigned long (*recalc) (struct clk *); | |
| int (*set_rate) (struct clk *clk, unsigned long rate); | |
| int (*round_rate) (struct clk *clk, unsigned long rate); | |
| }; | |
| /* Clock flags: SoC-specific flags start at BIT(16) */ | |
| #define ALWAYS_ENABLED BIT(1) | |
| #define CLK_PSC BIT(2) | |
| #define PSC_DSP BIT(3) /* PSC uses DSP domain, not ARM */ | |
| #define CLK_PLL BIT(4) /* PLL-derived clock */ | |
| #define PRE_PLL BIT(5) /* source is before PLL mult/div */ | |
| #define PSC_SWRSTDISABLE BIT(6) /* Disable state is SwRstDisable */ | |
| #define CLK(dev, con, ck) \ | |
| { \ | |
| .dev_id = dev, \ | |
| .con_id = con, \ | |
| .clk = ck, \ | |
| } \ | |
| int davinci_clk_init(struct clk_lookup *clocks); | |
| int davinci_set_pllrate(struct pll_data *pll, unsigned int prediv, | |
| unsigned int mult, unsigned int postdiv); | |
| int davinci_set_sysclk_rate(struct clk *clk, unsigned long rate); | |
| extern struct platform_device davinci_wdt_device; | |
| extern void davinci_watchdog_reset(struct platform_device *); | |
| #endif | |
| #endif |