| /* USB OTG (On The Go) defines */ |
| /* |
| * |
| * These APIs may be used between USB controllers. USB device drivers |
| * (for either host or peripheral roles) don't use these calls; they |
| * continue to use just usb_device and usb_gadget. |
| */ |
| |
| #ifndef __LINUX_USB_OTG_H |
| #define __LINUX_USB_OTG_H |
| |
| #include <linux/notifier.h> |
| |
| /* OTG defines lots of enumeration states before device reset */ |
| enum usb_otg_state { |
| OTG_STATE_UNDEFINED = 0, |
| |
| /* single-role peripheral, and dual-role default-b */ |
| OTG_STATE_B_IDLE, |
| OTG_STATE_B_SRP_INIT, |
| OTG_STATE_B_PERIPHERAL, |
| |
| /* extra dual-role default-b states */ |
| OTG_STATE_B_WAIT_ACON, |
| OTG_STATE_B_HOST, |
| |
| /* dual-role default-a */ |
| OTG_STATE_A_IDLE, |
| OTG_STATE_A_WAIT_VRISE, |
| OTG_STATE_A_WAIT_BCON, |
| OTG_STATE_A_HOST, |
| OTG_STATE_A_SUSPEND, |
| OTG_STATE_A_PERIPHERAL, |
| OTG_STATE_A_WAIT_VFALL, |
| OTG_STATE_A_VBUS_ERR, |
| }; |
| |
| enum usb_xceiv_events { |
| USB_EVENT_NONE, /* no events or cable disconnected */ |
| USB_EVENT_VBUS, /* vbus valid event */ |
| USB_EVENT_ID, /* id was grounded */ |
| USB_EVENT_CHARGER, /* usb dedicated charger */ |
| USB_EVENT_ENUMERATED, /* gadget driver enumerated */ |
| }; |
| |
| struct otg_transceiver; |
| |
| /* for transceivers connected thru an ULPI interface, the user must |
| * provide access ops |
| */ |
| struct otg_io_access_ops { |
| int (*read)(struct otg_transceiver *otg, u32 reg); |
| int (*write)(struct otg_transceiver *otg, u32 val, u32 reg); |
| }; |
| |
| /* |
| * the otg driver needs to interact with both device side and host side |
| * usb controllers. it decides which controller is active at a given |
| * moment, using the transceiver, ID signal, HNP and sometimes static |
| * configuration information (including "board isn't wired for otg"). |
| */ |
| struct otg_transceiver { |
| struct device *dev; |
| const char *label; |
| unsigned int flags; |
| u8 id; |
| |
| u8 default_a; |
| enum usb_otg_state state; |
| |
| struct usb_bus *host; |
| struct usb_gadget *gadget; |
| |
| struct otg_io_access_ops *io_ops; |
| void __iomem *io_priv; |
| |
| /* for notification of usb_xceiv_events */ |
| struct blocking_notifier_head notifier; |
| |
| /* to pass extra port status to the root hub */ |
| u16 port_status; |
| u16 port_change; |
| |
| /* initialize/shutdown the OTG controller */ |
| int (*init)(struct otg_transceiver *otg); |
| void (*shutdown)(struct otg_transceiver *otg); |
| |
| /* bind/unbind the host controller */ |
| int (*set_host)(struct otg_transceiver *otg, |
| struct usb_bus *host); |
| |
| /* bind/unbind the peripheral controller */ |
| int (*set_peripheral)(struct otg_transceiver *otg, |
| struct usb_gadget *gadget); |
| |
| /* effective for B devices, ignored for A-peripheral */ |
| int (*set_power)(struct otg_transceiver *otg, |
| unsigned mA); |
| |
| /* effective for A-peripheral, ignored for B devices */ |
| int (*set_vbus)(struct otg_transceiver *otg, |
| bool enabled); |
| |
| /* for non-OTG B devices: set transceiver into suspend mode */ |
| int (*set_suspend)(struct otg_transceiver *otg, |
| int suspend); |
| |
| /* for B devices only: start session with A-Host */ |
| int (*start_srp)(struct otg_transceiver *otg); |
| |
| /* start or continue HNP role switch */ |
| int (*start_hnp)(struct otg_transceiver *otg); |
| |
| }; |
| |
| |
| /* for board-specific init logic */ |
| extern int otg_set_transceiver(struct otg_transceiver *); |
| extern int otg_reset_transceiver(struct otg_transceiver *); |
| |
| #if defined(CONFIG_NOP_USB_XCEIV) || defined(CONFIG_NOP_USB_XCEIV_MODULE) |
| /* sometimes transceivers are accessed only through e.g. ULPI */ |
| extern void usb_nop_xceiv_register(int id); |
| extern void usb_nop_xceiv_unregister(int id); |
| #else |
| static inline void usb_nop_xceiv_register(int id) |
| { |
| } |
| |
| static inline void usb_nop_xceiv_unregister(int id) |
| { |
| } |
| #endif |
| |
| /* helpers for direct access thru low-level io interface */ |
| static inline int otg_io_read(struct otg_transceiver *otg, u32 reg) |
| { |
| if (otg->io_ops && otg->io_ops->read) |
| return otg->io_ops->read(otg, reg); |
| |
| return -EINVAL; |
| } |
| |
| static inline int otg_io_write(struct otg_transceiver *otg, u32 val, u32 reg) |
| { |
| if (otg->io_ops && otg->io_ops->write) |
| return otg->io_ops->write(otg, val, reg); |
| |
| return -EINVAL; |
| } |
| |
| static inline int |
| otg_init(struct otg_transceiver *otg) |
| { |
| if (otg->init) |
| return otg->init(otg); |
| |
| return 0; |
| } |
| |
| static inline void |
| otg_shutdown(struct otg_transceiver *otg) |
| { |
| if (otg->shutdown) |
| otg->shutdown(otg); |
| } |
| |
| /* for usb host and peripheral controller drivers */ |
| #ifdef CONFIG_USB_OTG_UTILS |
| extern struct otg_transceiver *otg_get_transceiver(int id); |
| extern void otg_put_transceiver(struct otg_transceiver *); |
| #else |
| static inline struct otg_transceiver *otg_get_transceiver(int id) |
| { |
| return NULL; |
| } |
| |
| static inline void otg_put_transceiver(struct otg_transceiver *x) |
| { |
| } |
| #endif |
| |
| /* Context: can sleep */ |
| static inline int |
| otg_start_hnp(struct otg_transceiver *otg) |
| { |
| return otg->start_hnp(otg); |
| } |
| |
| /* Context: can sleep */ |
| static inline int |
| otg_set_vbus(struct otg_transceiver *otg, bool enabled) |
| { |
| return otg->set_vbus(otg, enabled); |
| } |
| |
| /* for HCDs */ |
| static inline int |
| otg_set_host(struct otg_transceiver *otg, struct usb_bus *host) |
| { |
| return otg->set_host(otg, host); |
| } |
| |
| /* for usb peripheral controller drivers */ |
| |
| /* Context: can sleep */ |
| static inline int |
| otg_set_peripheral(struct otg_transceiver *otg, struct usb_gadget *periph) |
| { |
| return otg->set_peripheral(otg, periph); |
| } |
| |
| static inline int |
| otg_set_power(struct otg_transceiver *otg, unsigned mA) |
| { |
| return otg->set_power(otg, mA); |
| } |
| |
| /* Context: can sleep */ |
| static inline int |
| otg_set_suspend(struct otg_transceiver *otg, int suspend) |
| { |
| if (otg->set_suspend != NULL) |
| return otg->set_suspend(otg, suspend); |
| else |
| return 0; |
| } |
| |
| static inline int |
| otg_start_srp(struct otg_transceiver *otg) |
| { |
| return otg->start_srp(otg); |
| } |
| |
| /* notifiers */ |
| static inline int |
| otg_register_notifier(struct otg_transceiver *otg, struct notifier_block *nb) |
| { |
| return blocking_notifier_chain_register(&otg->notifier, nb); |
| } |
| |
| static inline void |
| otg_unregister_notifier(struct otg_transceiver *otg, struct notifier_block *nb) |
| { |
| blocking_notifier_chain_unregister(&otg->notifier, nb); |
| } |
| |
| /* for OTG controller drivers (and maybe other stuff) */ |
| extern int usb_bus_start_enum(struct usb_bus *bus, unsigned port_num); |
| |
| #endif /* __LINUX_USB_OTG_H */ |