| config P54_COMMON |
| tristate "Softmac Prism54 support" |
| depends on MAC80211 |
| select FW_LOADER |
| select CRC_CCITT |
| ---help--- |
| This is common code for isl38xx/stlc45xx based modules. |
| This module does nothing by itself - the USB/PCI/SPI front-ends |
| also need to be enabled in order to support any devices. |
| |
| These devices require softmac firmware which can be found at |
| <http://wireless.kernel.org/en/users/Drivers/p54> |
| |
| If you choose to build a module, it'll be called p54common. |
| |
| config P54_USB |
| tristate "Prism54 USB support" |
| depends on P54_COMMON && USB |
| select CRC32 |
| ---help--- |
| This driver is for USB isl38xx based wireless cards. |
| |
| These devices require softmac firmware which can be found at |
| <http://wireless.kernel.org/en/users/Drivers/p54> |
| |
| If you choose to build a module, it'll be called p54usb. |
| |
| config P54_PCI |
| tristate "Prism54 PCI support" |
| depends on P54_COMMON && PCI |
| ---help--- |
| This driver is for PCI isl38xx based wireless cards. |
| This driver supports most devices that are supported by the |
| fullmac prism54 driver plus many devices which are not |
| supported by the fullmac driver/firmware. |
| |
| This driver requires softmac firmware which can be found at |
| <http://wireless.kernel.org/en/users/Drivers/p54> |
| |
| If you choose to build a module, it'll be called p54pci. |
| |
| config P54_SPI |
| tristate "Prism54 SPI (stlc45xx) support" |
| depends on P54_COMMON && SPI_MASTER |
| ---help--- |
| This driver is for stlc4550 or stlc4560 based wireless chips |
| such as Nokia's N800/N810 Portable Internet Tablet. |
| |
| If you choose to build a module, it'll be called p54spi. |
| |
| config P54_SPI_DEFAULT_EEPROM |
| bool "Include fallback EEPROM blob" |
| depends on P54_SPI |
| default n |
| ---help--- |
| Unlike the PCI or USB devices, the SPI variants don't have |
| a dedicated EEPROM chip to store all device specific values |
| for calibration, country and interface settings. |
| |
| The driver will try to load the image "3826.eeprom", if the |
| file is put at the right place. (usually /lib/firmware.) |
| |
| Only if this request fails, this option will provide a |
| backup set of generic values to get the device working. |
| |
| Enabling this option adds about 4k to p54spi. |
| |
| config P54_LEDS |
| bool |
| depends on P54_COMMON && MAC80211_LEDS && (LEDS_CLASS = y || LEDS_CLASS = P54_COMMON) |
| default y |
