| /* TERMS AND CONDITIONS OF USE | |
| * | |
| * Redistribution and use in source form, with or without modification, are | |
| * permitted provided that redistributions of source code must retain the | |
| * above copyright notice, this list of conditions and the following disclaimer. | |
| * | |
| * This software is provided `as is' by Adaptec and | |
| * any express or implied warranties, including, but not limited to, the | |
| * implied warranties of merchantability and fitness for a particular purpose, | |
| * are disclaimed. In no event shall Adaptec be | |
| * liable for any direct, indirect, incidental, special, exemplary or | |
| * consequential damages (including, but not limited to, procurement of | |
| * substitute goods or services; loss of use, data, or profits; or business | |
| * interruptions) however caused and on any theory of liability, whether in | |
| * contract, strict liability, or tort (including negligence or otherwise) | |
| * arising in any way out of the use of this driver software, even if advised | |
| * of the possibility of such damage. | |
| * | |
| **************************************************************** | |
| * This driver supports the Adaptec I2O RAID and DPT SmartRAID V I2O boards. | |
| * | |
| * CREDITS: | |
| * The original linux driver was ported to Linux by Karen White while at | |
| * Dell Computer. It was ported from Bob Pasteur's (of DPT) original | |
| * non-Linux driver. Mark Salyzyn and Bob Pasteur consulted on the original | |
| * driver. | |
| * | |
| * 2.0 version of the driver by Deanna Bonds and Mark Salyzyn. | |
| * | |
| * HISTORY: | |
| * The driver was originally ported to linux version 2.0.34 | |
| * | |
| * V2.0 Rewrite of driver. Re-architectured based on i2o subsystem. | |
| * This was the first full GPL version since the last version used | |
| * i2osig headers which were not GPL. Developer Testing version. | |
| * V2.1 Internal testing | |
| * V2.2 First released version | |
| * | |
| * V2.3 | |
| * Changes: | |
| * Added Raptor Support | |
| * Fixed bug causing system to hang under extreme load with | |
| * management utilities running (removed GFP_DMA from kmalloc flags) | |
| * | |
| * | |
| * V2.4 First version ready to be submitted to be embedded in the kernel | |
| * Changes: | |
| * Implemented suggestions from Alan Cox | |
| * Added calculation of resid for sg layer | |
| * Better error handling | |
| * Added checking underflow conditions | |
| * Added DATAPROTECT checking | |
| * Changed error return codes | |
| * Fixed pointer bug in bus reset routine | |
| * Enabled hba reset from ioctls (allows a FW flash to reboot and use the new | |
| * FW without having to reboot) | |
| * Changed proc output | |
| * | |
| * TODO: | |
| * Add 64 bit Scatter Gather when compiled on 64 bit architectures | |
| * Add sparse lun scanning | |
| * Add code that checks if a device that had been taken offline is | |
| * now online (at the FW level) when test unit ready or inquiry | |
| * command from scsi-core | |
| * Add proc read interface | |
| * busrescan command | |
| * rescan command | |
| * Add code to rescan routine that notifies scsi-core about new devices | |
| * Add support for C-PCI (hotplug stuff) | |
| * Add ioctl passthru error recovery | |
| * | |
| * NOTES: | |
| * The DPT card optimizes the order of processing commands. Consequently, | |
| * a command may take up to 6 minutes to complete after it has been sent | |
| * to the board. | |
| * | |
| * The files dpti_ioctl.h dptsig.h osd_defs.h osd_util.h sys_info.h are part of the | |
| * interface files for Adaptec's management routines. These define the structures used | |
| * in the ioctls. They are written to be portable. They are hard to read, but I need | |
| * to use them 'as is' or I can miss changes in the interface. | |
| * | |
| */ | |