| MT8173 xHCI |
| |
| The device node for Mediatek SOC USB3.0 host controller |
| |
| Required properties: |
| - compatible : should contain "mediatek,mt8173-xhci" |
| - reg : specifies physical base address and size of the registers, |
| the first one for MAC, the second for IPPC |
| - interrupts : interrupt used by the controller |
| - power-domains : a phandle to USB power domain node to control USB's |
| mtcmos |
| - vusb33-supply : regulator of USB avdd3.3v |
| |
| - clocks : a list of phandle + clock-specifier pairs, one for each |
| entry in clock-names |
| - clock-names : must contain |
| "sys_ck": for clock of xHCI MAC |
| "wakeup_deb_p0": for USB wakeup debounce clock of port0 |
| "wakeup_deb_p1": for USB wakeup debounce clock of port1 |
| |
| - phys : a list of phandle + phy specifier pairs |
| |
| Optional properties: |
| - mediatek,wakeup-src : 1: ip sleep wakeup mode; 2: line state wakeup |
| mode; |
| - mediatek,syscon-wakeup : phandle to syscon used to access USB wakeup |
| control register, it depends on "mediatek,wakeup-src". |
| - vbus-supply : reference to the VBUS regulator; |
| - usb3-lpm-capable : supports USB3.0 LPM |
| |
| Example: |
| usb30: usb@11270000 { |
| compatible = "mediatek,mt8173-xhci"; |
| reg = <0 0x11270000 0 0x1000>, |
| <0 0x11280700 0 0x0100>; |
| interrupts = <GIC_SPI 115 IRQ_TYPE_LEVEL_LOW>; |
| power-domains = <&scpsys MT8173_POWER_DOMAIN_USB>; |
| clocks = <&topckgen CLK_TOP_USB30_SEL>, |
| <&pericfg CLK_PERI_USB0>, |
| <&pericfg CLK_PERI_USB1>; |
| clock-names = "sys_ck", |
| "wakeup_deb_p0", |
| "wakeup_deb_p1"; |
| phys = <&phy_port0 PHY_TYPE_USB3>, |
| <&phy_port1 PHY_TYPE_USB2>; |
| vusb33-supply = <&mt6397_vusb_reg>; |
| vbus-supply = <&usb_p1_vbus>; |
| usb3-lpm-capable; |
| mediatek,syscon-wakeup = <&pericfg>; |
| mediatek,wakeup-src = <1>; |
| }; |
