| Binding for NXP ISP1704 USB Charger Detection | |
| Required properties: | |
| - compatible: Should contain one of the following: | |
| * "nxp,isp1704" | |
| - nxp,enable-gpio: Should contain a phandle + gpio-specifier | |
| to the GPIO pin connected to the chip's enable pin. | |
| - usb-phy: Should contain a phandle to the USB PHY | |
| the ISP1704 is connected to. | |
| Example: | |
| isp1704 { | |
| compatible = "nxp,isp1704"; | |
| nxp,enable-gpio = <&gpio3 3 GPIO_ACTIVE_LOW>; | |
| usb-phy = <&usb2_phy>; | |
| }; |