| This file contains information for VSC9953, a Vitesse L2 Switch IP | |
| which is integrated in the T1040/T1020 Freescale SoCs. | |
| About Device: | |
| ============= | |
| VSC9953 is an 8-port Gigabit Ethernet switch supports the following features: | |
| - 8192 MAC addresses | |
| - Static Address provisioning | |
| - Dynamic learning of MAC addresses and aging | |
| - 4096 VLANs | |
| - Independent and shared VLAN learning (IVL, SVL) | |
| - Policing with storm control and MC/BC protection | |
| - IPv4 and IPv6 multicast | |
| - Jumbo frames (9.6 KB) | |
| - Access Control List | |
| - VLAN editing, translation and remarking | |
| - RMON counters per port | |
| Switch interfaces: | |
| - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs | |
| - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links) | |
| to FMan ports (FM1@DTSEC1 and FM1@DTSEC2) | |
| Commands Overview: | |
| ============= | |
| Commands supported | |
| - enable/disable a port | |
| - check a port's link speed, duplexity and status. | |
| Commands syntax | |
| ethsw port <port_nr> enable|disable - enable/disable an l2 switch port | |
| ethsw port <port_nr> show - show an l2 switch port's configuration | |
| port_nr=0..9; use "all" for all ports | |
| => ethsw port all show | |
| Port Status Link Speed Duplex | |
| 0 enabled down 10 half | |
| 1 enabled down 10 half | |
| 2 enabled down 10 half | |
| 3 enabled up 1000 full | |
| 4 disabled down - half | |
| 5 disabled down - half | |
| 6 disabled down - half | |
| 7 disabled down - half | |
| 8 enabled up 2500 full | |
| 9 enabled up 2500 full | |
| => |