| This file contains information for VSC9953, a Vitesse L2 Switch IP |
| which is integrated in the T1040/T1020 Freescale SoCs. |
| |
| About Device: |
| ============= |
| VSC9953 is an 8-port Gigabit Ethernet switch supports the following features: |
| - 8192 MAC addresses |
| - Static Address provisioning |
| - Dynamic learning of MAC addresses and aging |
| - 4096 VLANs |
| - Independent and shared VLAN learning (IVL, SVL) |
| - Policing with storm control and MC/BC protection |
| - IPv4 and IPv6 multicast |
| - Jumbo frames (9.6 KB) |
| - Access Control List |
| - VLAN editing, translation and remarking |
| - RMON counters per port |
| |
| Switch interfaces: |
| - 8 Gigabit switch ports (ports 0 to 7) are external and are connected to external PHYs |
| - 2 switch ports (ports 8 and 9) of 2.5 G are connected (fixed links) |
| to FMan ports (FM1@DTSEC1 and FM1@DTSEC2) |
| |
| Commands Overview: |
| ============= |
| Commands supported |
| - enable/disable a port |
| - check a port's link speed, duplexity and status. |
| |
| Commands syntax |
| ethsw port <port_nr> enable|disable - enable/disable an l2 switch port |
| ethsw port <port_nr> show - show an l2 switch port's configuration |
| |
| port_nr=0..9; use "all" for all ports |
| |
| => ethsw port all show |
| Port Status Link Speed Duplex |
| 0 enabled down 10 half |
| 1 enabled down 10 half |
| 2 enabled down 10 half |
| 3 enabled up 1000 full |
| 4 disabled down - half |
| 5 disabled down - half |
| 6 disabled down - half |
| 7 disabled down - half |
| 8 enabled up 2500 full |
| 9 enabled up 2500 full |
| => |
