| # File : small_debug.conf |
| |
| ######################### DBG Config command ############### |
| small_debug_enable={ |
| CmdCode=0x008b # do NOT change this line |
| |
| Dst:1=0x06 # dbgs_cfg_t |
| Air_Chan:1=0x00 |
| RSVD:1=0 |
| Num_Entries:1=0x81 # one entry global enable |
| |
| # dbgs_t |
| En_Mask:2=0x0000 # en_mask_id |
| BaseId:2=0x0000 # base_id |
| } |
| |
| small_debug_disable={ |
| CmdCode=0x008b # do NOT change this line |
| |
| Dst:1=0x00 |
| Air_Chan:1=0x00 |
| RSVD:1=0 |
| Num_Entries:1=0x00 |
| } |
| |
| ######################### DBG Get Trace Memory ############### |
| # Disable Air and Host destinations to disable dbgs_drain |
| # Enable only the Power save ID - Host interface is a course enable - not on specific event |
| trace_enable={ |
| CmdCode=0x008b # do NOT change this line |
| |
| Dst:1=0x00 # dbgs_cfg_t - don't drain debug |
| Air_Chan:1=0x00 |
| RSVD:1=0 |
| Num_Entries:1=0x02 # 2 entry |
| |
| # dbgs_t |
| En_Mask:2=0x5fff # en_mask_id - enable single ID=0x80 |
| BaseId:2=0x0020 # base_id |
| En_Mask:2=0x5fff # en_mask_id - enable single ID=0x80 |
| BaseId:2=0x0021 # base_id |
| } |
| |
| get_trace={ |
| CmdCode=0x008c # do NOT change this line |
| |
| startAddress:4=0x02 # read trace memeory - not a generic memory read |
| len:2=0x0000 # First read=0 - for next reads use the returned next start |
| } |
| |
| trace_disable={ |
| CmdCode=0x008b # do NOT change this line |
| |
| Dst:1=0x00 # dbgs_cfg_t - don't drain debug |
| Air_Chan:1=0x00 |
| RSVD:1=0 |
| Num_Entries:1=0x01 # one entry |
| |
| # dbgs_t |
| En_Mask:2=0x0000 # en_mask_id |
| BaseId:2=0x0000 # base_id |
| } |