| To install the second extended file system management programs, | |
| just follow the steps: | |
| 1) Change directory into the top of the e2fsprogs source tree | |
| 2) Create a build directory and cd into it: | |
| mkdir build; cd build | |
| 3) Run the configure script | |
| ../configure | |
| If you wish to turn on ELF shared libraries, add the option | |
| --enable-elf-shlibs. If you wish to build profiling libraries, add | |
| the option --enable-profile. | |
| Note that if you are building on an older system (i.e., a 2.4 | |
| kernel and/or glibc 2.2), the use of thread local storage will probably | |
| cause programs that use the uuid library to core dump. To disable | |
| thread local storage, use the configure option --disable-tls. | |
| 4) Compile the programs | |
| make | |
| 5) Check to make sure the installation built correctly: | |
| make check | |
| 6) Install the programs | |
| Run `make install' | |
| 7) Install the include files and libraries | |
| You can run `make install-libs' to install the include files and | |
| libraries. Please note that this installation is not needed for the | |
| programs to work. It is only needed if you expect to develop other | |
| programs using the libraries or if you want to compile other program | |
| using these libraries (like the 4.4BSD dump and restore port). | |
| 8) Remove any pre-formatted man pages. | |
| Some distributions will have pre-formatted manual pages which | |
| will always be displayed in preference to newer man pages in /usr/man. | |
| If this is the case, you may need to manually remove them in order to | |
| see the correct manual pages. The shell script in | |
| install-utils/remove_preformat_manpages may be helpful in doing so. | |
| 9) Make sure your /etc/fstab file is correct. | |
| Some distributions install an /etc/fstab which is missing the | |
| fifth and sixth field of filesystem entry, which are the dump | |
| frequency, and the fsck pass number, respectively. The problem with | |
| this is that the getmntent() library routine interprets those missing | |
| fields as "0", and a pass number of 0 is documented as meaning that | |
| fsck should not check that particular filesystem. If your entries in | |
| your /etc/fstab file look like this: | |
| /dev/hda4 / ext2 defaults | |
| you should add "1 1" at the end of each line, so that they look like this: | |
| /dev/hda4 / ext2 defaults 1 1 | |
| There is a script in install-utils/convfstab (donated by | |
| Michael Weller) that may help you correct your /etc/fstab file. | |