| # SPDX-License-Identifier: GPL-2.0+ |
| |
| obj-$(CONFIG_$(SPL_TPL_)CLK) += clk/ |
| obj-$(CONFIG_$(SPL_TPL_)DM) += core/ |
| obj-$(CONFIG_$(SPL_TPL_)GPIO_SUPPORT) += gpio/ |
| obj-$(CONFIG_$(SPL_TPL_)DRIVERS_MISC_SUPPORT) += misc/ sysreset/ firmware/ |
| obj-$(CONFIG_$(SPL_TPL_)I2C_SUPPORT) += i2c/ |
| obj-$(CONFIG_$(SPL_TPL_)INPUT) += input/ |
| obj-$(CONFIG_$(SPL_TPL_)LED) += led/ |
| obj-$(CONFIG_$(SPL_TPL_)MMC_SUPPORT) += mmc/ |
| obj-$(CONFIG_$(SPL_TPL_)CMD_JTAG) += jtag/ |
| obj-$(CONFIG_$(SPL_TPL_)NAND_SUPPORT) += mtd/nand/raw/ |
| obj-$(CONFIG_$(SPL_TPL_)PCH_SUPPORT) += pch/ |
| obj-$(CONFIG_$(SPL_TPL_)PCI) += pci/ |
| obj-$(CONFIG_$(SPL_TPL_)PHY) += phy/ |
| obj-$(CONFIG_$(SPL_TPL_)PINCTRL) += pinctrl/ |
| obj-$(CONFIG_$(SPL_TPL_)RAM) += ram/ |
| obj-$(CONFIG_$(SPL_TPL_)RTC_SUPPORT) += rtc/ |
| obj-$(CONFIG_$(SPL_TPL_)SERIAL_SUPPORT) += serial/ |
| obj-$(CONFIG_$(SPL_TPL_)SPI_FLASH_SUPPORT) += mtd/spi/ |
| obj-$(CONFIG_$(SPL_TPL_)SPI_SUPPORT) += spi/ |
| obj-$(CONFIG_$(SPL_TPL_)TIMER) += timer/ |
| obj-$(CONFIG_$(SPL_TPL_)VIRTIO) += virtio/ |
| obj-$(CONFIG_$(SPL_)DM_MAILBOX) += mailbox/ |
| obj-$(CONFIG_$(SPL_)REMOTEPROC) += remoteproc/ |
| obj-$(CONFIG_$(SPL_TPL_)TPM) += tpm/ |
| obj-$(CONFIG_AML_V2_FACTORY_BURN) += usb/gadget/v2_burning/ |
| obj-$(CONFIG_AML_V3_FACTORY_BURN) += usb/gadget/v3_burning/ |
| obj-$(CONFIG_AML_NAND) += nand/ |
| obj-$(CONFIG_AML_DRIVER) += amlogic/ |
| obj-$(CONFIG_SPI_NAND) += mtd/nand/spi-nand/ |
| obj-$(CONFIG_MESON_NFC) += mtd/nand/raw/aml_nand/ |
| obj-$(CONFIG_TYPEC) += usb/typec/ |
| obj-$(CONFIG_USB_ROLE_SWITCH) += usb/roles/ |
| |
| ifndef CONFIG_TPL_BUILD |
| ifdef CONFIG_SPL_BUILD |
| |
| obj-$(CONFIG_SPL_BOOTCOUNT_LIMIT) += bootcount/ |
| obj-$(CONFIG_SPL_CPU_SUPPORT) += cpu/ |
| obj-$(CONFIG_SPL_CRYPTO_SUPPORT) += crypto/ |
| obj-$(CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT) += ddr/fsl/ |
| obj-$(CONFIG_ARMADA_38X) += ddr/marvell/a38x/ |
| obj-$(CONFIG_ARMADA_XP) += ddr/marvell/axp/ |
| obj-$(CONFIG_ALTERA_SDRAM) += ddr/altera/ |
| obj-$(CONFIG_ARCH_IMX8M) += ddr/imx/imx8m/ |
| obj-$(CONFIG_SPL_POWER_SUPPORT) += power/ power/pmic/ |
| obj-$(CONFIG_SPL_POWER_SUPPORT) += power/regulator/ |
| obj-$(CONFIG_SPL_POWER_DOMAIN) += power/domain/ |
| obj-$(CONFIG_SPL_DM_RESET) += reset/ |
| obj-$(CONFIG_SPL_MTD_SUPPORT) += mtd/ |
| obj-$(CONFIG_SPL_ONENAND_SUPPORT) += mtd/onenand/ |
| obj-$(CONFIG_SPL_UBI) += mtd/ubispl/ |
| obj-$(CONFIG_SPL_DMA_SUPPORT) += dma/ |
| obj-$(CONFIG_SPL_ETH_SUPPORT) += net/ |
| obj-$(CONFIG_SPL_ETH_SUPPORT) += net/phy/ |
| obj-$(CONFIG_SPL_USB_ETHER) += net/phy/ |
| obj-$(CONFIG_SPL_MUSB_NEW_SUPPORT) += usb/musb-new/ |
| obj-$(CONFIG_SPL_USB_GADGET) += usb/gadget/ |
| obj-$(CONFIG_SPL_USB_GADGET) += usb/common/ |
| obj-$(CONFIG_SPL_USB_GADGET) += usb/gadget/udc/ |
| obj-$(CONFIG_SPL_DFU_SUPPORT) += dfu/ |
| obj-$(CONFIG_SPL_WATCHDOG_SUPPORT) += watchdog/ |
| obj-$(CONFIG_SPL_USB_HOST_SUPPORT) += usb/host/ |
| obj-$(CONFIG_OMAP_USB_PHY) += usb/phy/ |
| obj-$(CONFIG_SPL_SATA_SUPPORT) += ata/ scsi/ |
| obj-$(CONFIG_HAVE_BLOCK_DEVICE) += block/ |
| obj-$(CONFIG_SPL_FPGA_SUPPORT) += fpga/ |
| obj-$(CONFIG_SPL_THERMAL) += thermal/ |
| |
| endif |
| endif |
| |
| ifdef CONFIG_TPL_BUILD |
| |
| obj-$(CONFIG_TPL_MPC8XXX_INIT_DDR_SUPPORT) += ddr/fsl/ |
| |
| endif |
| |
| ifeq ($(CONFIG_SPL_BUILD)$(CONFIG_TPL_BUILD),) |
| |
| obj-y += adc/ |
| obj-y += ata/ |
| obj-$(CONFIG_DM_DEMO) += demo/ |
| obj-$(CONFIG_BIOSEMU) += bios_emulator/ |
| obj-y += block/ |
| obj-y += board/ |
| obj-$(CONFIG_BOOTCOUNT_LIMIT) += bootcount/ |
| obj-$(CONFIG_CPU) += cpu/ |
| obj-y += crypto/ |
| obj-$(CONFIG_FASTBOOT) += fastboot/ |
| obj-y += firmware/ |
| obj-$(CONFIG_FPGA) += fpga/ |
| obj-y += misc/ |
| obj-$(CONFIG_MMC) += mmc/ |
| obj-$(CONFIG_NVME) += nvme/ |
| obj-y += pcmcia/ |
| obj-y += dfu/ |
| obj-$(CONFIG_X86) += pch/ |
| obj-y += phy/allwinner/ |
| obj-y += phy/marvell/ |
| obj-y += rtc/ |
| obj-y += scsi/ |
| obj-y += sound/ |
| obj-y += spmi/ |
| obj-y += sysreset/ |
| obj-y += video/ |
| obj-y += watchdog/ |
| obj-$(CONFIG_QE) += qe/ |
| obj-$(CONFIG_U_QE) += qe/ |
| obj-y += mailbox/ |
| obj-y += memory/ |
| obj-y += pwm/ |
| obj-y += reset/ |
| obj-y += input/ |
| # SOC specific infrastructure drivers. |
| obj-y += smem/ |
| obj-y += soc/ |
| obj-y += thermal/ |
| obj-$(CONFIG_TEE) += tee/ |
| obj-y += axi/ |
| obj-$(CONFIG_W1) += w1/ |
| obj-$(CONFIG_W1_EEPROM) += w1-eeprom/ |
| obj-$(CONFIG_EFUSE) += efuse/ |
| obj-$(CONFIG_MACH_PIC32) += ddr/microchip/ |
| obj-$(CONFIG_DM_HWSPINLOCK) += hwspinlock/ |
| endif |