| # | |
| # Atmel device configuration | |
| # | |
| config NET_CADENCE | |
| bool "Cadence devices" | |
| depends on HAS_IOMEM | |
| default y | |
| ---help--- | |
| If you have a network (Ethernet) card belonging to this class, say Y. | |
| Make sure you know the name of your card. Read the Ethernet-HOWTO, | |
| available from <http://www.tldp.org/docs.html#howto>. | |
| If unsure, say Y. | |
| Note that the answer to this question doesn't directly affect the | |
| kernel: saying N will just cause the configurator to skip all | |
| the remaining Atmel network card questions. If you say Y, you will be | |
| asked for your specific card in the following questions. | |
| if NET_CADENCE | |
| config ARM_AT91_ETHER | |
| tristate "AT91RM9200 Ethernet support" | |
| depends on GENERIC_HARDIRQS && HAS_DMA | |
| select NET_CORE | |
| select MACB | |
| ---help--- | |
| If you wish to compile a kernel for the AT91RM9200 and enable | |
| ethernet support, then you should always answer Y to this. | |
| config MACB | |
| tristate "Cadence MACB/GEM support" | |
| depends on HAS_DMA | |
| select PHYLIB | |
| ---help--- | |
| The Cadence MACB ethernet interface is found on many Atmel AT32 and | |
| AT91 parts. This driver also supports the Cadence GEM (Gigabit | |
| Ethernet MAC found in some ARM SoC devices). Note: the Gigabit mode | |
| is not yet supported. Say Y to include support for the MACB/GEM chip. | |
| To compile this driver as a module, choose M here: the module | |
| will be called macb. | |
| endif # NET_CADENCE |